Recent content by monighan

We took our Mule to the HCEA national convention at Brownsville,PA last week end to use as a support vehicle for my antique Caterpillars. We met another fellow Mule owner from Indiana.[/url]

RE: Mule tires 25-10-11 I think. I'd have to look .

RE: Mule tires I like my Goodyear Tracker P's http://img179.imageshack.us/img179/4772/1001970bk2.jpg

Do you have the mount that attaches to the frame rails?

I asked the other day, What does one of these demilled 106's cost? How easy to get one?

Took the Mule out Sunday for cross contry ride. http://www.youtube.com/watch?v=iMeHchRXp3w http://www.youtube.com/watch?v=7wdZ73cmcGA http://www.youtube.com/watch?v=kg5XSa0e3qU http://www.youtube.com/watch?v=cej6EFJPiEM http://www.youtube.com/watch?v=Ax-ZKSK9ZZU

What does one of those cost in that condition?

If you don't want it you can give it to me! I would like one of those for my Mule.

I did a genset motor swap this week and it was very easy. It did take a little longer because I sand blasted all the ducting and what ever else needed cleaned up and repainted. These are the things needing changed; oil pan/windage tray,gear cover,bell housing,oil lines,flywheel,belt pulley,drain...

What's the bore and stroke of the 2A042? Is it 3''x3'' like A042 in the Mule? If so why did gbooth say the crank is different?

It'll only throw you if the timing is off. I have an old 1930 Caterpillar 60 (4cyl 1200cu in.) and it fires right up with a 2' long bar in the flywheel. Of course the compression cocks need opened.

about 24'' tall

the coil is probably breaking down when it warms up .or maybe just clean points.rebuild mag or get a new one.

Day late dollar short -story of my life for most things like everybody else aua . I'm very happy I was able to snatch my A5 up last month.You should have not hesitated and grabed it ,the hell with the engine! Anyhow,I can't wait till friday when we go to deer camp so we can cruise around on...

where you located? (NOT ON THE EDGE OF THE VERSE)