Recent content by MrBouncer

Unless the mounts on it are new I am going to replace them. I will not be putting a third adapter in.

I am sure someone has ordered mounts from LMC for the motor and transmission. I see three different sets offered for the transmission that "look" compatible. Part number 34-0320(upper)/34-0322(lower). Then 34-0361(complete set). Which ones??

I plan on replacing the crossmember and adapter mounts. suggestions on where to find them. Thanks for all the help and thanks for any future help.

Could having one hub locked and not the other one cause enough stress to cause this? Maybe combined with worn mounts and a crossmember that is bent every so slighty. When I say slighty as in not noticable with eye but will not line up with bolt holes in the frame. Off less than a quarter of...

Dont remember the name of the company I ordered this one from, I just remember it came from New Hampshire, but this adapter has been in the truck for at least three years. I became very aware of forklift damage when the first one failed. I would think that any lift damage not addressed with the...

It was parked for a couple of weeks, wouldnt start so I pushed it to the garage to put the charger on it. Maybe 40ft. Did that and went about my business later that day noticed the puddle of tranny fluid under it, checked it out and found the crack. . I can only assume that it had already began...

This is the second failure of the transfer case adapter mount I have had. Can anyone give me ideas on what and where to look for the problem. All LOOKS good but there has got to be something else wrong. And also where to find another.

This is kinda sorta related to his the thread. Has anyone ever broke the plastic turn knob on the lock out hubs? (the plastic piece that you actually put hands on and turn to lock or free) Can not find the technical name for it in the manuels. Can only that piece be purchased?

86 CUCV "stock" with the exception of doghead starter relay mod and GP controller card bypass, has ran fine for years but here lately has been stalling, only when cold and only after a sudden rpm change. Such as when fast idle kicks off, quick mash of fuel pedal and when stopping. And only...

Can someone give me the estimated cost of a brake job on a 1028? Going to redo lines and completely replace front and rear. Need an idea before I approach my finace manager... AKA wife.

My neighbors don't mind mine because i don't get stuck in the ditch in the front yard anymore.

Well new switch solved the problem but I would like to give a word of advice for the folks that think and act as I do. When doing electrical work on you vehicle always double check the blackout light switch. It will save yourself alot of headache and embarrassment.

Since this a thread on weird a lighting problem and the problem that started it has been solved I hope no gets upset if I kinda hijack this thread instead of starting a new one. I have headlights(high and low), brake lights, turn signals, hazards and black outs. No park lights or dash lights...

Can anyone give me any information on these? They were mounted to the firewall behind the air intake.

Above the sunvisors in the 1028 there is a small hole with a rubber plug. The actual use of these I do not know. But you can fish a coax cable through it down the back behind weapon mount out the bottom through a drain plug to the rear or as I plan to right out the top of the truck. The...