Recent content by otrafxp

Thanks Willwagner I will try and contact them

Were do you buy repairkit for the air hydrovac ? It sfor the M35, i am looking for 10-20 pcs

Hello i have a problem with my dump truck, i have to use the emergency stop wire to shut of the engine, because when i use the normal switch it will not stopp. What Can the problem be ? it is a 1984 truck

Hi. is there any way to tell from the vin number What year the m939 series of truck is produced ?

I need the old 1983 one because that has the weight data in it, i am going to Get licenseplate on 2 trucks here in Norway, and need the data for the dmv

Ytes i have checked those, there are only the newer editions

Hi i am looking for the operators manual for the m939 series, the 1983 edition on PDF. Dose anbody have that or a link to it ?

Thanks for all help. It was the ip pump that was bad on it, found one used, changed it, now it works.

I have bypassed the fdc on the fuelpump, checked timing, checked the shut off its free. When i crank it i Get fuel to the nozzels It still will not start without starterfluid and have to be above 1000 rpms to run on the pump the stop plunger is a 6 o clock and not 7 o clock, Can this be...

Will check this weekend

The head was a nos one and i have changed the complete injectors.

I have changed all filters and the shut off valve under the cover on the side of the pump is moving free. i had the same problem before i changed the head.

I have a problem with my deuce, when i try to start it up it just cranks and will not start. IT only starts if i use starterfluid on it. when it starts up then i have to ild eit above 1200 rpm or Else it just dies out. I have replaced the hydrolic head and nozzels on it. What Can be the...

Hello Contact Olav Teigen. He can supply volvo trucks Olav Teigen Maskinforretning +4732756045 +4797057125

Hi Looking for the ORD SNL G-742 manual on pdf