Recent content by pangea

I how much for 200 amp alternator

o

My 4wd was not working till I cleaned out my filter of metal particules. The module had small bearings and parts of the bearing races stuck in it. Now 4x4 "mode" works great! If I could only get rid of that grinding sound. Lol

Many lmtv owners do not know this but there is a steel mesh filter in the transfercase where the scavenge pump hose attaches to. The scavenge pump mounts on the right side of the transmission. Clean this filter or lose youre pump, transfercase and trans$$$. Pull the shift module on rear of tcase...

Hi, My name is John (Pangea). I was over 1/2 way back on a recovery of a M1079A1 & had some transmission problems. I need a towbar tow to Amarillo & have a tow bar but need a safety chain & air lines. Anyone up for an adventure? Truck is about 7 miles west of Oklahoma City in a safe...

So , I realized I told you all 1078A1, the truck is actually a 1079A1 sorry. My 24 volt on 12 volt issue has been resolved. Who ever put the surefire arctic heater in the rear box wired it wrong. Thanks to the wiring diagrams I was able to figure out the "work light" fuse and the "arctic Heater"...

Gentlemen, I do believe the man who put that electronics file on the board needs a promotion. Thank you so much. Tomorrow I will fix this.

Thank you. I did put a request in at NSN CENTER for the wiring/electric manual and Robert Page replied and asked if i was military or state And said the request is for a very expensive truck". LoL:tank: side it would be about $300 if authorized

I pulled all the breakers and fuses and did not change issue. With all the fuses and breakers out I still had 24 volt on 12 volt side. I then proceeded to pull the plugs on the panel with breakers and fuses out and found J307 plug had one wire #1674 that showed 24 volts on voltmeter. With the...

Oops sorry J307 plug not 306.

Ok, I'm back. I found connector J307 wire #1674 on 12 volt board side has the 24 volts causing whole 12 volt side to have 24 volts. Any idea what J306 wire #1674 goes to? Man, if it wasn't so wet and cold out.

OK, the dash lights coming on are the warning lights on the display and not the gauge lights. When I switch the ignition switch to on the rest of the display lights come on and I hear relays being energized. The truck is a 2001 A1 cat3126. Thank you superman. happy new year everybody. Signing...

Both relays and wires and switch wires are on correctley. On the 12 volt battery side of relay it is 12v, but the other side "12v" relay to panel it is 24volt.

OK, so batteries connected properly, alternator 12 and 24 OK, polarity box 24 volts on 2 upper lugs and 12 volt on two lower lugs. On the fuse panel the 24 volt and 12 volt wires are correct. If I connect the 12 volt to fuse panel only the 12 volt side gets power. But if I connect 24 volt to...

I just put a new dash/gauge assembly ,wire harness, and fuse/relay in the truck. This was all MIA when I got her. I double checked all connections went to start and turning over but no start. Checked the panel and have 24 volt on the 12 volt lug. New batteries installed and 12 and 24 volt at...