Recent content by paramilusmc

Did a search and read the TM and couldn't find the size of the rivets. I'm buying a rivet tool and just want to make sure I am getting the right size tool for the job. Thanks

So master cylinder rebuild fixed the geyser problem. Now I have a leak somewhere else int he system where air is getting in. So ya, fun fun.

Yup, that is how I adjusted mine. It happens with both air in the system and no air in the system.

NOS, bought from Big Mike

Well yes, but the system didn't have any fluid in it to begin with.

Yup, that's how they were adjusted.

Yes but only when letting off the pedal. Comes out the top yes. I will check

Yes, both Major and Minor adjustments per the TM completed.

Hello all, did a quick search and didn't find anything like the issue I am having. So here it goes. I got a 1971 AM General 2.5 ton. When purchased didn't have any brakes. Went through the whole system, replaced the Master Cylinder, Air Pack, one rear brake line, all wheel cylinders, three...

Well, got the starter rebuilt and went to put it on. What I additionally found was that the bolt didn't fall out. It broke off up inside the bell housing. Not sure what would cause that condition, but I decided that wasn't work I had time to perform. Also had them take the hubs apart and...

Very good points. Gives me something to think about.

Ok, I need some education. CDR? IP? Having just pulled the starter off myself, yes very certain it is oil. In matter of fact I am all but certain that the oil is what lubed the starter bolts and enabled the vibration and torque from starting to work them loose. For the past couple of months...

I was hoping that wasn't the case. Anyone done a rear main seal on one of these ole girls? How much is that going to set me back?

So starter went today. While taking it off to bring it in for a rebuild I noticed allot of oil around the work area. Reason it went was a bolt fell out (kind of surprising) and when I went to try and turn it over the starter twisted and broke off a portion of the starter housing and wouldn't...

Well my pipes have rotted off and its time to re-do the exhaust. Man it will be nice not getting all the fumes leaking up through the tailgate for a change. I want to put a HMMWV fording exhaust on my M1009. I got a guy that says he can do the work. Just wondering what you all thought, and or...