Recent content by PFH

The door needed to be that high due to the floor plan i wanted. The 150gallon water tank is almost centered over the frame in the box next to the cab, then the bed is over that, then the pass thru is right above the bed. I‘m adding reinforcing, a spreader bar will be added under the door, from...

Getting ready to finally install my locker and gears, but I would like to check the lash before. Anyone know what the lash measurement is on these? TIA

I bought 12 feet of the bellows gasket. I found some metal trim behind the shop and made two square frames to attach the gasket, one for the cab and the other for the box. The box side frame is attached permanently and the cab side is removable, to be able to raise the cab when necessary. The...

This is where its at as of this rainy morning. Been working on the pass through.

I used a box off a Box Truck (moving truck) for my current project. Seems to be working out good

Could anyone please tell me the approximate travel of the air ride on the cab, from empty to full. (no batteries right now or I‘d measure it myself) Thank you in advance.

Thanks, I just got back home from an awesome trip to SEMA. Got a lot of great ideas from the builds there. Fun trip but glad to be home. I going to catch up on my chores, then get back to working on the truck. Thanks again

Thank you for the praise. Just doing what I can on limited budget and lack places to get the fancy materials. Most of the stuff for the inside is second hand and came from Habitat for humanity and Craigslist. The walls are used bamboo flooring, the kitchen counter is a mahogany headboard for a...

It has a sub frame semi hard mounted with spring on the cab end and single point pivot at the rear.

This is what I’ve got done to the inside so far. I always wanted a cabin in the mountains but never did, so I’m making the inside have a cabin look to it, sort of. Put 2.5” of insulation in all the walls and ceiling, then used 1x6 t&g bamboo for the wall. Has a kitchen with an apartment size old...

It’s started as a 14’ x 8’ box off a box truck (moving van) I got from a salvage yard. I added another 2’ by sectioning the box on the cab end.

I didn’t know there was a cover, I’ll fab one up. Thank you

Thanks, would’nt be needing that where i live, but ill replace it anyway.

Wow, fast response, and local part numbers too!!! Thank you very much. Does it hurt anything to drive without it?

Can someone please tell me what is suppose to be in the circled are in the photo. This is on a 1998 M1078. Thanks in advance.