Recent content by profo

I have a few (4) 1400r20 michelins with approx 80-90% may have small cracking 50 bucks ea. but will only bring if someone wants them, I have new in box unimog(see) injection pump ($500),silicon brake fluid in galions $20. Also have m151 engines with transmissions, some running gear and hood...

Will see yall there

Fuzzy , Found software on internet recommend any version number?

Check for power to and through CB42 on you PDP fuzzy what are you calling the pdp? passengerside dash panel? I have been trying to figure my abs light for years I do have cat et , but not the wabsco software for abs , so been trying manual to figure out playing swap a part! Marty

there a place where I bought some 4.7kw that will fit the yanmar 7 hp that is in the mep the guys name is shane huffman and you need a gen to fit the j09b size. IMD LLC Tel.: 864.968.0858 Ext:1014 Fax: 864.968.0878 www.imd-us.com

yes the guts are the same from what i found!

I have finally tracked down the manufacture for the lmtv air hydraulic pump that lifts the cab lowers tire etc. it is made by spx/otc you can rebuild it by using the internal parts that come from their 4023 and pa50 models the most common part that goes bad is called a Ucup part number 253095 or...

Hey Juan just wanted to update you I am going only in 5 ton camper to air show , not bringing the lmtv. So me and family will only constitute one vehicle.

Me and pretty much whole family will be there Saturday and camping at signet

Me and shelly gonna be there Thursday eve

I haven't looked at mine but all of them are switchs the two in back,one for front bucket is a single pole double throw temporary on off on. The other is on off amazon sells some that snap right in that are similar as for the tool switch it's a pull on switch on off you can get that at napa. It...

I plan on coming got to get some stuff in order but will give 100 percent notice on 14th.

this will help also you got to find the wire 22 in under the circuit board /fuse panel and cut the one going to the rear connector and this is the brake controller output, tie your controller output to this wire, if I remember there were two one going to the front and one to the rear. all the...

its probably the regulator its turns on/off the 12 and 24 charging intermitingly thats the lil lights that blink back and forth basically cycles 12 then 24 and the 12 side is not working which is most common problem with the regulator fail, I change them on my lmtv camper almost every other year...

mouser electronics is in texas, just google them been doing business with them for over 20 years good people!