Recent content by ralbelt

I have always said HF is one job tools, use it and toss it.

I did it on my M1008, one of the first things I did. When I got the M1009 I went to do it and found out the PO had already done it.

Following, what is the part number for the printed circuit. LMC has a few listed not 100% sure on which one. Thank You

Been cleaning up the electrical on the M1009. Removed the Dixie horns and all the wiring that went with them. Tested the glow plugs and the push button to activate them. Took out about 20 feet of extra wire and cable the PO had installed. Pulled the instrument cluster cleaned up connections and...

Good looking truck , best of luck with it.

Welcome aboard.

Mine is starting to crack, I had it recoloured about 5 years ago, I'm thinking of removing it and having one of the local sign companies do a wrap on it. '

Did you bleed the fuel filter?

I would go with 47,000. Looks like a good truck.

Is one of the fittings cross threaded ?

I need to replace the rocker panels and probably the cab corners while at it on my M1008. Anyone prefer one supplier of the other?

What Tinstar said, I did mine last fall , 1984 K30 got everything no problem. a good time to do all the brake lines and front brake hoses also.

A Snapper axle boot Part #7075115YP inside diameter is 1 and 3/4 inches full extension is 9 inches, just FYI if needed.

When they are on the 24v circuit as one fails more is sent to the remaining and so on causing them al to fail, there is a lot of info on here about it.

Install the AC 60Gs, you can grind the tabs to fit or change the terminal to fit. I also changed the glow plug circuit to the 12v terminal to prevent cascading failure.