• Steel Soldiers now has a few new forums, read more about it at: New Munitions Forums!

  • Microsoft MSN, Live, Hotmail, Outlook email users may not be receiving emails. We are working to resolve this issue. Please add support@steelsoldiers.com to your trusted contacts.

Ray70's latest activity

  • R
    Ray70 replied to the thread No AC output.
    Take the fuse out of the holder and test it. it is a slow blow fuse, but there is no such thing as a time delay reset fuse. Remove it...
  • R
    Ray70 replied to the thread 1969 MEP 10K Generator.
    $48!? Does that particular TM weigh 40 lbs. or something? it should qualify for USPS media mail for like $5, sounds like someone is...
  • R
    Ray70 replied to the thread No AC output.
    Ah, I see... I read where you said Hz at 60 and everything else was working and I assumed that meant the outlet was also working...
  • R
    Ray70 replied to the thread MEP-802A questions.
    Make sure you get every last speck of sand out of the thermostat housing and the water passages. Also might want to change the gasket...
  • R
    Ray70 replied to the thread No AC output.
    Didn't you already say the HZ meter and outlet were working? if so you are making power. I've just skimmed over this whole thread...
  • R
    YUP, just be careful, the center of the filter is usually the downstream / output side, so anything you pour in will go unfiltered into...
  • R
    Before pulling the injector, take 2 minutes and load it until it bogs, the push up on the linkage and see if engine revs up or not. That...
  • R
    Fuel leaking from around the throttle shaft assembly will not cause your issue. It sounds ( as dog Breath mentioned ) like a lack of...
  • R
    Ray70 replied to the thread 50s Continental TD427.
    Regarding you oil/water mixture, oil floats on top of antifreeze so you should use a syringe, siphon or other device to see how much oil...
  • R
    Ray70 reacted to Guyfang's post in the thread MEP 803A - Clueless in Texas with Like Like.
    What really needs to be done here is teach you to read a TM. 1. TM 9-6115-642-24 is the operators TM. 2. TM 9-6115-642-24P is the Parts...
  • R
    Ray70 reacted to kloppk's post in the thread Generator TM errors with Like Like.
    What I did was just a test markup to see if it's possible. Basically, it's just adding text "notes" to an existing PDF. I don't have a...
  • R
    Ray70 reacted to Guyfang's post in the thread Generator TM errors with Like Like.
    If we are going to do it, than its better, I think, in at least two places.
  • R
    Ray70 replied to the thread Generator TM errors.
    It probably belongs on the page with the picture of the CVT winding, but can we add a note to that page, figure 6 7.1 that says an "002...
  • R
    Ray70 reacted to kloppk's post in the thread Mep003 Putting out 300 VAC and stalling with Like Like.
    Also visually check the VR board for burned components. I've repaired a number of the VR's and besides the three transistors failing...
  • R
    Correct, most likely its the VR. Typically 1 of the 3 transistors on the VR goes bad. There is a testing section in the TM, but you...
Top