-
Steel Soldiers now has a few new forums, read more about it at: New Munitions Forums!
Ray70's latest activity
-
RRay70 reacted to Light in the Dark's post in the thread Great when they work, and are ready on standby with
Like.
Power went down about 450 last night, and came up at 8A this morning. 802 never missed a beat. -
RRay70 replied to the thread MEP803A - 0W40 Oil.I suppose so! That means you are legally obligated to go out and buy more.... just to be safe!
-
RRay70 replied to the thread MEP-802A questions.On the o-ring gasket, there are 2 of them, however in your picture the 2nd one is still inside the block. That tube is a short stub with...
-
RRay70 replied to the thread No AC output.Now I'd try a continuity test from VR 5 and 6 to F+ and F- on the exciter board ( item #10 ) as Kurt indicates in his chart above. If...
-
RRay70 replied to the thread MEP-802A questions.That strip is of little importance. You can go to Home Depot and get a roll of sticky back foam rubber tape and use that instead. They...
-
RRay70 replied to the thread MEP-002a possible Injector Pump Issues.Well, the good news is that since it was able to hold a full load in the past, to me that indicates the governor arm is most likely not...
-
RRay70 replied to the thread No AC output.For future reference you can go to the top of the forum page. You will see a bar with "Rules" "TM" and "Vendor Spotlight" listed...
-
RRay70 replied to the thread No AC output.Section 2-27 on pages 95/96
-
RIf the Fuse Mod fuse is good and you don't have power the the outlet then you need to perform the AC Voltage Regulator test. Post up...
-
RRay70 replied to the thread MEP-802A questions.If you can't get the gasket in time, you can also purchase a 12"x12" square of gasket material from your local auto parts store and cut...
-
RRay70 replied to the thread No AC output.Take the fuse out of the holder and test it. it is a slow blow fuse, but there is no such thing as a time delay reset fuse. Remove it...
-
RRay70 replied to the thread 1969 MEP 10K Generator.$48!? Does that particular TM weigh 40 lbs. or something? it should qualify for USPS media mail for like $5, sounds like someone is...
-
RRay70 replied to the thread No AC output.Ah, I see... I read where you said Hz at 60 and everything else was working and I assumed that meant the outlet was also working...
-
RRay70 replied to the thread MEP-802A questions.Make sure you get every last speck of sand out of the thermostat housing and the water passages. Also might want to change the gasket...
-
RRay70 replied to the thread No AC output.Didn't you already say the HZ meter and outlet were working? if so you are making power. I've just skimmed over this whole thread...