• Steel Soldiers now has a few new forums, read more about it at: New Munitions Forums!

  • Microsoft MSN, Live, Hotmail, Outlook email users may not be receiving emails. We are working to resolve this issue. Please add support@steelsoldiers.com to your trusted contacts.

Recent content by recorder

  1. R

    CTIS quick disconnect valve rebuild or replacement options?

    good tech advise will do test this weekend thanks
  2. R

    Rear seat belt options?

    looking for rops seat belt kit
  3. R

    black smoke

    air filter new , does not have restriction gauge , cleaned egr was not carbon up ordered a new map sensor # 12569241 oem part . will post result as soon i receive map sensor thanks for reply
  4. R

    black smoke

    My mistake 6.5 turbo slow accelaration or else it will blow black
  5. R

    black smoke

    97 h1 5.6 turbo blows black smoke on accelaration and bogs light pressure it will clear up
  6. R

    m151a2 ignition switch wiring diagram

    very helpful ,also for my lights
  7. R

    m151a2 ignition switch wiring diagram

    Thank you great help will wire in new switch
  8. R

    m151a2 ignition switch wiring diagram

    does any one have a diagram for ign on off switch with wire numbers and thier location on rear of switch old switch was removed and location list was lost, should have taken a picture lokked at tm does not state numbers thanks Terry
  9. R

    m151a2 ball joints

    Thanks for info will replace as you stated
  10. R

    m151a2 ball joints

    did any one modify front ball joints by drilling and adding grease fittings ordered nos front ball joints none come with greese fittings thanks terry
  11. R

    m37b1 front end aligment

    does any one have the spec, for feont end alignent of 1963m37b1 ar is there any tm with this infotmation
  12. R

    M37 "creating" legroom

    make me an offer
  13. R

    M37 "creating" legroom

    m37b1 sgteering wheel change used a steering from a m151a2 which is about 15 inches and shaped in upward angle. the jeep steering wheel had to be bored out to approx 20.7 mm and then pressed fit on to m37 colum shaft before installing wheel i placed a brass washer which is size you can use as...
  14. R

    M37 "creating" legroom

    m37 steering wheel change
  15. R

    M37 "creating" legroom

    will do as soon as get some time will take pics
Top