Recent content by Redah

Thank you 87Nassaublue.

Thank you DieselAddict. I will follow your suggestion and report back, it may take me a while, as I just started another project (Cargo Trailer Conversion). I will keep monitoring the topic.

Any suggestions?

Back where it was before, plus, now it's tripping breaker even with 1 of the 5 wires on the 'Fuel Level Switch' disconnected, the same wire that cured the tripping problem before :mad::mad:

I just tried to start it, but it won't unless I push the 'Governor Linkage' in, and maintain it pushed. When I let go off of it died. It also tripped the breaker. Now with the wire I snipped earlier still unconnected, the circuit breaker trips when I move 'Master Switch' to 'Run Aux Fuel'. Did...

I went back to wire #11 on the back of ‘Master Switch’ (photo #3) and ‘Fuel Level Switch’ (photo #4). Disconnecting one or the other resulted: No tripping, but no start. I traced wire #11 to the ‘Fuel Level Switch’ and snipped it. I know can turn the ‘Master Switch’ to pass ‘Run Aux Fuel’...

Disconnected electric fuel pump power wire (blue arrow, photo #5 above). Still the same. Disconnected electric connector on Solenoid (red arrow, photo #6&7 below). Same result.

Thank you Speddmon for answering my message. Later today, I'll be following the suggestion that Suprman's and You recommended. I'll report back with results.

Much Obliged Suprman, I will try it tomorrow and update.

Suprman, Would you kindly using the 4th photo, guide me to which power wire you are referring to.

MEP-016B Tripping DC Control Circuit Breaker Hello Everyone, I’m having a problem with the ‘DC Control Circuit Breaker’ tripping on a MEP-016B with 1824 Hrs. Got this little monster a month ago. Flushed fuel lines and tank, replaced fuel filter, refilled with fresh fuel and put in 2 new 12V...