Recent content by Redneck92

It ran perfectly before with no Problems at all. Transfercase is in H gear. I also checked the linkages from the transfercase and the trans. I did not Drop the pan nor checked the filter yet. Fluid on the dipstick looks perfekt. When I Shift the trans to R or D it shifts firm in a split...

When I cleaned all the connections I had the batterys unplugged. After that I plugged them in again and made a 5 mile test drive. Symptoms as before, trans light flashing when the engine is running or when I drive it. After the test drive I bridged A and E on the TCM again and no codes...

Yes I did let it finish blinking. Besides Code 12 there are no other codes stored. Very unusual I think.

Hello Guys, I´m currently working od a M1123 6.5 NA with the 4l80e transmission. My problem is, that the trans seems to be stuck in limp mode. When I turn the ignition switch to the run position, Glownox does it´s thing, Trans light is glowing. When I start the car, the trans light starts...

Okay thank you for the information. I will do that. Gesendet von meinem SM-A415F mit Tapatalk

Didn't think of that. The original Checkvalves were all badly rustet. That stuff needs to go somewhere... What is the easiest way to air up the truck With shop air? In the P2P I saw that the rear emergency gladhand goes to the Trailer push valve unter the steering wheel and would then end in...

So, the Problem didn't leave me alone.... I went back to the truck and tested some stuff. I gave Shop air to the service gladhand and didn't hear any air leaking. Then I removed the Shop air. Started the truck up and Opened the shutoff valve to the primary tank. Primary would not buikd air as...

I'll check that tomorrow and report back. Thank you for your Quick help with this. Gesendet von meinem SM-A415F mit Tapatalk

Took a screenshot from one of your Videos. Red arrow: no air from the line nor the Port. Yellow arrow: there is little air flowing from the line if I take that line off. If I hold the line shut it will build a little bit of pressure but not much. Neither secondary nor primary gauge will move...

The App does not send my pictures that I hat taken.... Idk why.... Gesendet von meinem SM-A415F mit Tapatalk

There is no air coming out of that Port nor the line Gesendet von meinem SM-A415F mit Tapatalk

It looses air immediately wether the parking Brake is on or off. Gesendet von meinem SM-A415F mit Tapatalk

That is not what I wanted to hear.... How ca I identify which diaphragm went out exactly? Gesendet von meinem SM-A415F mit Tapatalk

Hi guys I´m back with another problem. Today I tinkered with my electric a bit since somebody cut and rewired my light switch connector. Long story short, I told my girlfriend to step on the brake pedal so I could watch the back brake lights. She stepped on it pretty hard and when she...

I put a m1982 LMTV flatbed on to my m931 truck. Needed to cut the storage boxes out for the side panels and the ladder, painted the underside and the bedside. Still need to Do the wiring. Gesendet von meinem SM-A415F mit Tapatalk