-
Steel Soldiers now has a few new forums, read more about it at: New Munitions Forums!
Ronmar's latest activity
-
RThe heat index recently has motivated me to finally put my A/C in over the last month. I know others are feeling the heat. There was a...
-
RI am very glad I did this! Looked great inside, popped off the outer clutch pack snap ring and lifted out the clutch pack and carrier...
-
-
RRonmar replied to the thread Trans / T-case temperature gauges.The A0 plumbing only sends engine heat toward the trans untill the trans becomes a heat source. Thats why it takes so long to warm up...
-
RRonmar replied to the thread LMTV rough idle on startup?.Yep, everyone should check this. It is the foundation of diesel operation and a VERY common point of failure. Since all the system...
-
-
ROn our 2003 M1078A1 with the 3126 the tee fitting @Ronmar is mentioning is aside the primary fuel filter to the rear under the rear cab...
-
RRonmar replied to the thread Trans / T-case temperature gauges.“Do you think the thrust bearing gets damaged from shock loading during a specific shift?” Perhaps. the P6 carrier and plates appears...
-
RRonmar replied to the thread LMTV rough idle on startup?.Well find the pressure sample port near the main fuel filter alongside the head(not the water separator with the primer). It should be...
-
RRonmar replied to the thread LMTV rough idle on startup?.What year truck? with diesels I always start with primary fuel supply. A loose fitting or filter seal, or pinhole in a line will allow...
-
RRonmar replied to the thread Trans / T-case temperature gauges.I added engine and trans oil temp gauges to my dash but have not added the sensors. i was also looking at utilizing the oil sample...
-
RGiven the 3116's oil line of death issues it certainly is unfortunate they didn't fully implement that feature. Not the only...
-
RRonmar replied to the thread LMTV Volt Gauge Readings.yea I am fairly convinced that the only thing S&S could wire to spec is an electrical fire…
-
RRonmar replied to the thread Do I need this??.well the one that is plugged in, is the water separator bowl heater. The other one may be the low oil level circuit, which lights a...
-
RRonmar replied to the thread Sitting for 5 years. Help me get it running?! Please!.The part number from the 24p manual is 29507766
-
RRonmar replied to the thread 1998 LMTV Hot transmission - No drive.The trans goes out thru the bottom. Go to the manuals section from the steel soldiers main page, present conflict vehicles lmtv you...
-
RRonmar replied to the thread LMTV Volt Gauge Readings.yep, if you are setting in the seat, the power panel should roll right out and lay upside down onto your knees, takes about 2 minutes to...
