Recent content by Rusty1340

Sorta like mine she was gone. The tub was in non-restorable condition no floor side panels missing 3 inches from the bottom and 2 inches from the top cowl top and firewall rusted away. I understand all parts are available but you can't weld to rust. The engine, trans, axles, frame were complete...

I've read your entire thread and have to say good job you've come a long way, at the same time I'm now a little nervous because I'm looking at a 1990 923A2 this weekend with 30,000 on the clock and after seeing what you worked through I'm not sure I could. But now I know too some of the things I...

Well that was short lived running like crap again. I blew out the gasket between the intake and exhaust manifold and not sure I can change it without broken bolts and or manifolds. Thinking of a repower with a Cummins 4BT.

I been preoccupied with other things around the house but I haven't completely ignored the M 37 a while back I was experiencing low power and backfiring issues when it was under a strain. after a little research and some checking around I found a positive coil wire was arcing on the side of the...

I have the TM9-1826A PDF file if you still need it I can send it to you.

Did you do the rebuild or have it done and what kit did you use? I need to do mine Thanks

Vintage Power Wagon has them if John dont

I'm in need of a Dzus clip and stud so I can reinstall my instrument panel any laying around? Or point me to who may have them Thanks

No need to apologize. We all get the benefit of good information and that's what its all about.

Thanks that's the pictures I needed. Yeah I spoke with the glass shop and he's done a few before I'm just going to drop off the frames. Thanks

Way better then rolling it around in the yard. That works great I done several motorcycle tanks this way. But the cement mixer was genuine for sure.

I have my windshield frames all ready for new glass does anyone have the measurements of the actual glass. I probably should have went the other route just buy new assemblies. But to late to turn back now.

For that price you almost just have to take a chance and order it especially if you need one.

That would be great love to see what I'm up against. Thank you

Oh figures I'm going to need some hardware Thanks