Recent content by s011883

I had the same thing and pushed the reset button on the speed sensor. It fixed my problem. Good luck

I had the same thing and pushed the reset button on the speed sensor. It fixed my problem. Good luck

Have you pushed the reset button on the speed sensor? It sound like you are just running on the day tank.

002A is a good generator. I power my 1595 sq ft home with it. I can run my ac unit that has a LRA of 72.5 Amps. It starts it ok, but once it's up and running it only pulls a RLA of 15 Amps. I changed all my light bulbs to LED. We turned every light on in the house (main floor and full...

I have done it both ways, but just for a split second, and then it will take off. I have also taken the exciter apart, checked every connection, and the bolts.

Hello. I have a 30 kw generator that will not flash by itself. If you take a 9 volt battery and manually flash the generator on the side, It will start producing power and continue until you shut it off. I've sent the speed switch and exciter box to Delk's to check it out. He put them on a...

Thanks for the info

Delks will have used ones

When the master switch is set to AUX you should have power to all three fuel pumps. The aux pump fuel is turned on and off by the electric fuel solenoid which is controlled by the fuel tank float.

Try putting 1/4 quart of ATF in your fuel and if that doesn't work then pull your injectors and have them checked out.

Welcome. You'll be able to get all your questions answered here.

I use 120' # 4 SO cord to run my 003 generator at my house. I went with the #4 for voltage drop and so I could keep the generator 100' from the house. Those connectors that came with your cable cost big $$.

I have a mep003a that ran good but just didn't sound right and a friend told me to put a little ATF in the fuel. I put about 1/4 of a quart per 10 gallons of fuel. It only took about 15 minutes and engine's sound changed tone and ran even better. I was talking to my injector guy about this...

If anyone is interested, I would be willing to sell all the parts in a kit that you build.

Here is a schematic of my load tester. The cost to put this together was around $100.