-
Steel Soldiers now has a few new forums, read more about it at: New Munitions Forums!
Scoobyshep's latest activity
-
Scoobyshep replied to the thread Ground and neutral wires on MEP-003A.Yes there should be 4 wires total 2 hots 1 neutral and 1 ground -
Scoobyshep replied to the thread Ground and neutral wires on MEP-003A.disconnect the small wire and tape it off. (assuming you are talking on the output board) neutral to LO a phase to L1 b phase to L3
-
Scoobyshep replied to the thread 805a and a 10 wire gen end.In a typical 12 lead zig zag, the normal paralleled windings are still in parellel. This diagram parallels a leg a with a leg c I...
-
Scoobyshep replied to the thread Fried Volt Meter.electrons had a party. It looks like one connection was loose and that makes heat. You're probably fine with just a replacement meter.
-
Scoobyshep replied to the thread Ground and neutral wires on MEP-003A.6awg should be the neutral and the 10awh should be the bonding jumper. I feel it's important to warn you that if this is disconnected...
-
Scoobyshep replied to the thread Looking to replace the missing 60Hz Gauge on my MEP-803A....eBay is a good source. I usually end up with reed style gauges. Don't forget to bypass the transducer
-
Scoobyshep replied to the thread Mep-807a issue.Line loss can be mitigated by larger wire or using a boost transformer. Fuel consumption though will be epic. Sent from my SM-S908U...
-
Scoobyshep replied to the thread Trying a new idea for the exhaust on my 802a.My set is about 20 feet from the house in its own shed. Conduits are sealed with duct seal and fire stop. Sent from my SM-S908U using...
-
Scoobyshep replied to the thread Trying a new idea for the exhaust on my 802a.That would do it. Cheap insurance here would be having a co monitor in the house. Sent from my SM-S908U using Tapatalk
-
Scoobyshep replied to the thread Mep-807a issue.The worst hurricane I can recall recently here was Irma, it left me in the dark for 9 days and that was the year I got my first MEP...
-
Scoobyshep replied to the thread Mep-807a issue.I'm also in FL, I can get away with a 10k (but I cheat I have alot of gas appliances). Typically before a generator project you'd do a...
-
Scoobyshep replied to the thread Mep-807a issue.You have a 300 amp service, I doubt you are routinely pulling 300 amps. This is kind of one of those things where you need to measure...
-
Scoobyshep replied to the thread Mep-807a issue.My 15 k is overkill. This is 10x overkill. I can only imagine what the fuel consumption is per hour on this beast Sent from my SM-S908U...
-
Scoobyshep replied to the thread Mep-807a issue.Okay I do believe you are winning the prize for the most amount of overkill on this one
-
Scoobyshep replied to the thread Mep-807a issue.Absolutely the right set of priorities. If you don't mind me asking what are you planning to use such a large set for? Sent from my...