Recent content by scottofazphx

Im in Phoenix AZ, so 70% of the year its crazy nice outside and not hot. I take the truck off-roading during this time of the year. During this time I run the half doors for the open-air experience. My truck is stored inside a garage so security not an issue. However, in the middle of the summer...

Im working up a multi striker now for my truck. I have a set of x doors with the round bar striker and a set of half doors that grab a striker that looks much like the soft doors just solid. I want to be able to switch between the doors at anytime depending on the weather without changing out...

Yep, first time mine turned on i thought something blew up!

So for anyone else that might have this issue in the future. I did have a bad turn signal stock, but also the cannon plug internals where turned 180 degrees.

Never mind, figured it out thats the turn signal stock

Anyone have any idea what and where this is?

mounting bar is not in place but i have tried with jumper between the two bolds and if i open up the fixture (remove lens) i can see its internally jumped. Both studs go to same internal ground plate. Plus other side also does not have plate and is working as it should. But thank you for the...

Ill give that a test later today, thanks for the idea! Yes i meant 22-461, good catch ;-)

Yes, I tested the ground through the harness at the light. Also the other lights like turn signal and marker light is using same ground and is working at the corner. Im guessing its a connection someplace that is allowing volts but no current through. Guess ill have to start in the rear and work...

I have a m1165 I have been restoring and have a weird issue. The driver side break light does not work. You would think its a bulb, so easy enough repair but here is the issue. The old busted up light didn't work so I order a set of incandescent ones and an LED set for after the rebuild is done...

Ahh!!! yea bet you are correct, that would make sense since turn signals dont work.

Anyone have an idea what this 3 pin cannon connector under dash might go to. Truck is 2006 M1152. Also wondering what the military did to the M1152 trucks before they restickered as M1165. My truck serial plate says its a M1152, but the sticker in the footwell says M1165 and if i look at it with...

Yep, that's what I found out. I tested the old fluid and its DOT 5. separates water just as it should. Thats a relief, now just going to bleed lines till I get new purple fluid coming out and call it good. Thanks for all the info and hopefully this short thread will help others in the future.

Yea im thinking it's probably best to remove some of the fluid left in the reservoir and test it to see if it mixed with water. Maybe they used a yellow DOT 5, seems it exists. Then I think I'll bleed some out at the rear caliber and do the same and/or see if its purple. If still unclear I...

So I picked up a M1152 that was purchased from GovPlanet couple years back and has been sitting ever since. When I got it delivered to me, I noticed when brake pedal was engaged fluid would squirt out at the proportion valve. Well come to find out someone took off the one hose that cost like 300...