Recent content by Sergey G

Yep.))) it says ford power stroke e and F series. So must be the wrong one? No chance this one will work

It does show 5 ohm to the smaller S stud, nothing to the I

This one was listed for any 6.2 and 6.5 l chevy engines, why do you think it might be the wrong one?

Thank you guys again. One more question. I have bought a glow plug switch which is different than my original and I have problem to which of the smaller studs the blue wire from gP module should go to - to the I side or S side? I' m attaching the photo of it.

Super!����thanks!!

Thanks, guys, no need to jump any. Then bypass. The proper way to connect it would be the negative of the battery closest to the firewall, right? Fusible link would be a must?

What about putting in a modern type 24-12 v converter 300watt so I have steady 12v?. I still do not get the engineering idea if this ballast resistors being 24 v and dropping it to 12 under load - glow plug switch 12v, gp 12v. I imagine it should give 12 v right when it reaches gP switch...

Thank you. Is there a way to check resistors with ohmmeter? Mines were also smoking several times really bad, so I m seriously thinking of resistors bypass.

Thank you, that clears out . But isn't there a way to check resistors with a ohmmeter? I had an issue where my resistors were giving burnt wiring smell , almost smoked few times. I' m concerned they are functioning not properly under load. Just want to avoid burning bright new glow plugs.

I have a concern that my glow plugs fried due to malfunction of resistors. The way I checked resistors was supplying 24 v to them and getting the same 24 v on the other end which goes to glow plug switch. I have an extra used resistors which showed 24 v on the out end as well. Does that mean...

Let me know if this happens so I can give you any possible assistance locally

Thank you guys, and thank you all for all good information, advice and posts that you have here. As I said over the years I have been trying to keep its original condition but given the fact that I want to use it more often I will have to do some mods that will help me easy every day start and...

Hi guys, I'm a new member here but i have been picking up a lot of useful information here for a long time. I own my m1010 for 8 years now and I've inherited it from Kazakhstani gov that was donated a stock of 100 cucvs by us gov about 20 years ago. Mine was in very good technical condition, the...