Recent content by ssgtcampbell77

So I did some looking around on line. For the new gear reduction starter, bolts and bracket Im lookin at around $150 (with shipping) and having to wait 3-10 days for arrival. I found a rebuild shop down the road that can rebuild for about $175 with a 24 hour turn around. Im gonna go with the...

The bracket pn# is 22502557 (as originally posted by Warthog) and confirmed my my local Chevrolet dealer. I will update when they actually get it in.

Bench tested the starter. She's done. I found one online at rareelectrical, doesn't look the same though. Do you think this will work? NEW 24V STARTER MiLITARY VEHICLES 6.2L DIESEL ENGINE

Sorry, I missed that. Thank you.

Warthog, you said you knew where to get ahold of solenoids? I may need your help shortly. Thank you.

Update: I checked my starter relay this morning and it is working just fine so I pulled the starter out, gonna bench test it in a little bit. Im hoping its the solenoid and not the starter.

Hahahaha.... seriously, I had the same issue. Pull all your connections and clean them (one at a time so as not to cross wire anything). If that doesnt work, check your relay (under dash). When I cleaned all my connections, problem solved. Then I cooked my relay (or starter solenoid....not sure...

Advanced Auto pn# S603 - $39.99

.78 cents under the floor matting, a slim jim, a magnetic retriever stuck to the block and 3 different oil leaks. If I ever sell it, its going out the same way.....78 cents included.

The first rule of owing a CUCV, "If its rubber replace it, if its electrical clean it".

Clearly.

Your middle line is a drain. The line closest to the cab is your return and the line closest to the bed is your feed. Reference TM 9-2320-289-20 page 3-32 and figure 3-13. And Im wearing flip flops.

The relay I referred to is in TM 9-2320-289-20P Fig 32 (picture), pg 32-1 item 3 (part and number). I have not done the Doghead as of yet but I had planned on it next week. Of course my starter beat me to the punch. I have been cleaning connections all day and am about to pull the relay (under...

I didn't see you posted those pictures, mine is the bigger one on the left. I finally have some time off so Im gonna get to the starter today. Before I yank that starter out, Ive got a question or two. First, The TM shows a relay near the starter and one under the dash but in the schematics, I...

Gotcha, makes sense. I put mine on a lift so I didn't have an issue with the axle nor did I need to remove the starter. Although as luck would have it, now that i have the oil pan issue solved, my starter is done. Hopefully just the relay or solenoid. If I ever get off work I will start on that.