Recent content by Ssmax

Im in, Thanks!!

A Detroit in one of these would be awesome, I can only imagine my neighbors reaction to that lol. That ISX swap sounds pretty interesting, 600hp would be amazing to have in this heavy pig, i'd imagine there would have to be some modification to the Allison or a whole other trans altogether no...

Really good to know! yes lol I'm looking to just keep the transmission. So right now we have some bad weather coming for CT. As soon as that blows over i'll get going on the removal of the head ( going to be doing this outside). I'm planning on starting early next week. I'll start another...

Awesome guys thanks a lot... All really good things to consider, I did find a few big cam cummins but great to know its going to be a bit more involved swapping that into an A2 truck. I'll just cross that off the list lol... I'll check out some places online tonight where i can find either 3116...

So I have an m936a2, which i know for a fact has a blown head gasket and most likely a cracked liner or many. Burns coolant, blow by, overheats, exhaust in the coolant and coolant in the oil... Could go on lol...Having said that I've been on here look at different engine rebuilds and 6CTA tare...

Awesome man, I'll give ya a call later about that

Yeah its an Eaton, I wasn't able to get a picture of it for you guys but I saw the sticker on the back where it said Eaton. I was able to get a reading of tire pressure in highway mode and all the tires were between 78-80psi. I'll get the other readings when my neighbors are up so I won't wake...

Awesome I'm going to get on that probably tomorrow. I'll also get those pictures you wanted of the ECU when I get out of work. FWIW before I left for work the truck cycled from sand to cross country, to highway twice with the light coming on solid for each setting. Also it wasn't in run flat...

I've manually aired up the tires to 80 when I first got the truck. Rode great, the wrecker is a heavy girl as it is. I had a 923 I kept it at 55, and that was great. Yeah I'm starting to see it can be a really finicky system. Since my last post though I've successfully cycled from highway to...

This is when the truck was in the runflat/ Highway mode. secondary looking like its filling tires. this is after i heard the pcu clicking Here are the other pictures you requested. I will say that after the truck went through a few fill/ dump cycles the run flat light turned off from...

OK so I think we might be getting somewhere, I tried the run flat setting while being in highway and about 3 mins after the truck hit psi the valve clicked and started bringing secondary pressure down... would that mean it's filling the tire to highway? Ignoring the leaks?. I'll post pics that...

Thanks for the reply guys, so the air pressure to start in the tires are 80psi I aired em up manually, I checked the air connections at the pcu, no leaks there. I have the yellow line and black air line going to it, Both the cannon plug on the side and 3 pin connector are fully connected. I...

Hey guys I'm Dave. I recently picked up an m936a2. I'm having an issue with the CTIS ( big surprise) I've searched this site quite a bit and I've read the dana eaton troubleshooting guide. But I still haven't found anything addressing the problem I have. The issue is I start the truck, the...