Recent content by steve6x6x6

Eaton has no locker for the RF-611 Meritor axle.

That locker is for a 1983 and up F600 and F700, Rockwell F106 FDS or rear.

Hello, i do check my messages from time to time

Ouverson has a 5.13 ratio but by the time you put 3 chunks assembly's on the work bench and buy the 3 gear set kits ($1,800 ea.) and some bearings and lots of labor = $7,500. Just go buy some 11.00 tires and be done with it.

There is one more gear that goes on top of all of that, it fits on the spline and drives all 4 planet gears

I fab the 5 1/2" round tube housings and make the tube fork ends. I make the axles shafts from alloy 4340. 225,000 tensile strength per square inch.. The customer wanted 3.90 gear ratio final drive, all axles are driven with lockers in both rears.

I have built axles with welded planets but were for a truck that weighted 1/2 what a M1078 does and much smaller tires. I do not have pic's of the welded planets for the rears. Pic's are for basic info., do not ask me to build these axles, because a lost my rear end making them.

All loaded up and ready to ride tonight.

Looking for appleton 100 amp. plugs and receptacles, new or used.

Will anybody be bring some of those large bumper vises?

I am in winter haven

Yes i can bring new complete take off planets, the same front and rear $400 a pair.. I can also bring some planet setup tool, $50 ea.

Not yet, it is getting close though.

Will anyone be bring those work vies, big bumper mounted ones?