Recent content by Tater6

When the no charge light comes on does the 2 lights on the regulator flash. If they do not check to see if tl35 the lug close to the front to see if it has 24 ish volts. If they do flash check the back lug for 14ish volts. Both tests with engine running.

So do you still have a no charge light on with the ctis harness unplugged. Or what other issues do you have with the truck.

Did you test the wire I just tested had 3.5v with truck off and power off but main power by battery box.

Sorry didn't see the question. yes was wire j1587 in the c.t.i.s harness right at the 90 elbow connection. Basically the wire was getting 24v and should be max of 7v I think. With a meter tested at plug showed 24v then when I moved it a little it would drop to 7v moved it back and go back to...

I would go back and chalk all wires of items replaced or swapped out. Also to answer you question about the wire to test it is wire #J1587 this wire should have I think max of 7v. This wire can be found on the test port 'F' when you hook up the test equipment. Also on the c.t.i.s harness at Port...

Let me find my wiring schematics or an old harness. I do know that one of the wires should only have around 5 to 7v. This wire runs to all the diff. Ecms in the truck. And is spliced under the pdr box on passenger side (relay box). I belive 5 or 6 total splices. Give me about an hr and I should...

Do you have any transmission codes. Turn power switch in cab on then If you press up and down arrow at the same time it will pull up your diagnostic codes. Example if you have 2 codes it will show d1 then 13. 2nd code will show d2 the the code of let's say 69. So the d# is only a reference to...

So you turn power on you have at least 25v to the starter. You hit the start switch and it only makes a click noise at the starter.

Steve what info are you needing

But I don't think it keep it from starting. Just kept it from shifting.

I have one time on a mtv wrecker but it was only after someone did some work on the trans. But I was not apart of the work. I can ask my friend that did the work to find out. When u turn power on does the push button trans says NN correct. It could be the nutral start switch that is bad or a...

Sand cobra when your no charge comes on does the oil pressure gauge stop working and the 24v stop. But 12v is fine. If so try unplugging the c.t.i.s harness that should do the trick. If it does not turn battery power off on the c.t.i.s harness you will see a little "a" and the next pin above to...

I see it's been a year but have you tried to unhook the c.t.i.s harness from the box. I have noticed that once it is unhooked the oil and 24v gauges will start working and the gen /alternator will also start flashing. The harness I belive might be bad. 3 or 4 trucks I have worked on in the last...