Recent content by tmcnaney

Well glad to know Im not the only one with the staring issue. I just replaced the clutch after blowing it up two years ago. Drove the truck home, was moving something’s as one does and the safety starter fuse blew. It now keeps blowing. Seams to be when the clutch pedal is pressed. It’s been...

I was able to move 5-6 dumptruck loads....then it stopped moving. Today I was able to back up a hill, then it got stuck in a small dip. Neghibor said sand in the bell housing might help.....

I went off-roading with my Unimog and accidentally let the clutch out moving at about 10-15mph in low low gear. I engaged the pedal again and used the break to slow down. When I tried to move again from a stop there was barely any power going to the transmission. I had the truck towed back home...

I’d like to nominate my 419FLU Sent from my iPhone using Tapatalk

Does anyone know the weight of the backhoe on the 419? I removed it today, however now there is not enough weight to use the bucket. Need to counter balance the backhoe until I can replace the seals Sent from my iPhone using Tapatalk

That looks like it might go there. Check out this link https://expedition-imports.com/0026-00-2-Figure-25-Fuel-Pumps-%E2%80%93-Metal-Tube-Assemblies_c_385.html Sent from my iPhone using Tapatalk

New here! Just purchased a FLU419, have the front bucket off, seams slower uphill now? I reworked the air cables in the high low as they were broken. I am thinking that the plumbing is wrong. I also only have “2” diff lock, also part of the air system. Going to review the value system next...