Recent content by TurboTim

Anyone know where to get them. When I sent my manifold back to CM automotive they lost some of the fittings.

Well you can take this for whats its worth but when I switched out my trans fluid. I added synthetic. I dont think this was a good idea because the trans would run hotter. I am thinking this is because it was a thinner fluid. So I drained that out and added dex 3 and some thick Lucas trans oil...

You guys are correct but you are missing the whole point. How do you think the CTIS gets air? It gets it from the truck. There is an output that you guys are talking about but there is also the input from the trucks air that feeds CTIS. If I remove this there will be 2 hoses from truck going to...

Is there 2 different temp sensors like there are 2 different pressure sensors?

When I remove the manifold there will be a huge air leak. There are 2 ports that feed it air. Think about it. These are what I need to plug.

Yeah and like I said the pan was around 165 so I am guessing that the gauge is just off a bit.

Im going to send my CTIS to get reprogrammed and a solenoid replaced. Does anyone know a good way to plug it so I can still drive it?

The trans temp has always read on the high side of the guage, like in the 270's. I suspect the guage is wrong because pan only is 160 with a temp gun on the worst days. I also noted it was highest with synthetic AT fluid and has dropped with standard fluid. I also added some thick Lucas and it...

I got one to fit on stock location. The tread goes inbetween the seem for the storage box.

Here is a nice front shot.

I think the stockers are considered 43's and 395's are considered 47's so just a couple inches taller. The tires just look bad ass cause they are so wide!

My rotor are 280mm. I will measure the thickness later. Those seem like okay prices. I am trying to swap them onto a Volvo V70R I will see if I can located the caliper that is supposed to be used. Are yours faded from track use or not? I have found them before but they where always faded. I...

Didnt know they made axial mount brembos? How much you want for them?

Want to sell some of those calipers?