Recent content by TXMIDGUFFREY

Gimme stuff please

I'm trying to download this font but get a 404 error. Any suggestions?

Where may I find your IP rebuild project. I already rebuilt the IP. Just need to get the two halves of the fuel supply pump to mate well. There is no gasket so I'm assuming that the two have to be lapped to mate perfectly. Can you confirm? Thanks for your knowledge and experience.

Hey master mechanics.... has anybody ever bypassed the IPs Fuel Supply Pump assy and maybe installed an electric pump? I've got a bad fuel leak from the mating surface of the 2 parts of the housing. As far as I can figure, to get to that I'm gonna have to either remove the steering column, or...

I'll do the bleed for sure. Where can I find info on going "in the hubs to verify the wheel cyls are good"

Expert experienced advice please. '71 M35a2 - brake pedal goes to the floor, no resistance, master cyl is full, no air leaks Troubleshooting guide leads me to "Air-Hydraulic Cylinder" I found a rebuild kit at Mike's Motor Pool but it calls it M35A2 2.5 TON AIR PACK REBUILD KIT 8345007 Am I...

1971 M35a2, bought it knowing there was a problem with the IP/HH Calling all mechanical experts out there.... I just rebuilt my IP, having had to replace the Hydraulic Head. I cleaned and de-rusted the fuel tank, flushed all fuel lines, replaced all filters and cleaned/blew out all injector...

Know a source for a hydraulic head?

I need a source for a replacement Hydraulic head, anyone got a source? 90100A,

Howdy from Lindale, TX

I'm having a little trouble identifying my IP. It looks like a "G", in that it has no compensator. But the fuel pump cover design looks like the C, D or E cover. The HH that is on it now (and is completely FUBAR) is HD90100A How can I tell for sure? Tag reads PSB6A-90EH-5337A3