• Steel Soldiers now has a few new forums, read more about it at: New Munitions Forums!

  • Microsoft MSN, Live, Hotmail, Outlook email users may not be receiving emails. We are working to resolve this issue. Please add support@steelsoldiers.com to your trusted contacts.

Recent content by usmc434

  1. U

    PRC-77 help...

    Old radio trick....might work... take a pencil eraser and clean radio and hand set contacts....we always had to do this .....
  2. U

    why would diode blow on exciter

    thank you for your reply....i did a run test without load its same all is working...also found a dirt dobber mud nest built around one diode.....two were bad out of three........
  3. U

    why would diode blow on exciter

    mep017a 30 hrs when i bought at gsa auction....track down two blowed diodes on exciter.....could someone tell me why and what would cause failure.......before i test gen, larry in alabama
  4. U

    MEP-017a Carb Issues

    2ao42 floats are copper the floats are copper on the 2ao42 eng. for the mep017.....gen larry in alabama
  5. U

    MEP-017a Carb Issues

    Make sure your fuel tank vent is open or not cloged...trash unger needle value ..or float or neddle value stuck....float out of ajustment...
  6. U

    MEP-017a Carb Issues

    Mep017 carbs Army surplus warehouse has eng. 2a042 mep017 nos carbs for $19.00 and $5.00 shipping ...no rebul. Kits available....best to replace when carb .. Go bad. Larry in alabama
  7. U

    thank you

    my mep003 and mep017 are operational thanks to your past posts Larry in Alabama
  8. U

    question mep017a on the k2 and k3 relay

    in the TM-14 page 4-44 is the operations of the relays they work together in junctions with each other closing and opening circuits heres a small sample... 1,,,,,,,,k1 starts Eng. 2........k2 stop Eng. 3........k3 energized charger rectifier 4........k4 energized threw...
  9. U

    question mep017a on the k2 and k3 relay

    i just found it in the -14 thank you larry in alabama
  10. U

    question mep017a on the k2 and k3 relay

    i cant find what the k2 and k3 relay controls on panel A in the manual . could someone fell me..i think k1 start and run battery charger .......k4 oil pressre guage .......k2 ? .......k3 ? i had to swap k4 to k1 to keep engine running in nomal mode ..thanks to the past posts still...
  11. U

    mep003...mep017 fuel lines

    thank you on the fuel lines info mep017 1.replaced carb. fuel pump .fuel lines.cleaned fuel filter screen..clean plugs and gap...eng. runs good.. 2 replaced battery VR.. 3...flash fields 4...had voltage out put but lost it 5..pulled main gen.VR old style found to bad diode cr9 and...
  12. U

    mep003...mep017 fuel lines

    hello i am a military vehicle collector...i have recently bought at auction two gens a mep017 and mep003 i have the manuals....but i will need help with gen.problems questions 1 all fuel hoses need replacement......will upbraided auto fuel line work just as good 2 on the mep017 with a...
  13. U

    mep0117a wire 5 f and wire 6 f on vr test

    no output voltage hand volt meter plug into power aux outlet 12v car batty, jump to wire 5 f and to other battery post to wire 6f power came from 0 v to 10.5 v ac with a bad vr .what else does this reading show are the fields working.OK... does it only generate as much voltage as applyed to...
  14. U

    Working MEP Gensets on GL?

    mep017 and mep003a bought a mep017a GSA sales auction ..$195..193 total hrs 130 hrs gov. rebuild..replace carb, fuel pump. fuel lines,,eng. runs good ..cyl pressure check 125 psi...it had a 12 volt battery mounted not the 24 v kind......downside battery vr diodes bad..reg. on order......had...
  15. U

    What all MEP models do members have?

    mep003a 640 hrs mep017 a 190 hrs/ 3 kw motor home gen oman new ? koalor ? hours 2 mules m274a5 m151a2 3 uarl bikes m1009 m37 47 willys
Top