Recent content by Valleyordnance

Hi guys, Anyone have a line on a OT-64 manual? Looking for PMCS info mainly. Just bought one that runs and drives but needs some love Thanks! Chris R

Hi Guys, Thought I would try to see if anyone has a dead wiper motor around they would be able to sell me the arm off of? I cannot find a part # for the arm alone, it's the small one that bolts onto the wiper motor with the double balls Willing to buy and pay shipping thanks! Chris

No - haven't messed with the pads on either end yet, there looks to be better than half a pad left. Like I said I jacked up each end of the truck and free spun the wheels to make sure there was nothing dragging. my other Hmmwv's will want to crawl if you put them in Drive with the brake off...

Jacked up one end at a time and free spun the wheels to ensure the brakes weren't dragging. Should have released any windup. This isn't my first HMMWV - Just the first one I can't figure out.... Thanks for the suggestion though, keep them comming. I'll figure it out sooner or later. Chris

New to me truck - Bought it about a year ago, just finally getting a chance to mess with it. Chris

Just straight forward and backward 30 ft in my gravel drive

Hi Guys, Need some input on a problem I'm having with my '95 M998, 6.5 w/3L80e Trans. Shifting into drive with the t-case in H, the truck acts like the E brake is on, takes a lot of pedal to get it to move. Jacked up the front and rears to see if the brakes were dragging, all wheels spin...

2 pushrods, New head gasket, Exhaust and intake gaskets and a rocker cover gasket later the truck runs great! Thanks for the help

Borrowed a compression tester from a buddy and did a compression test. #2 cylinder is dead. Pulled the valve cover off the drivers side and one of the bolts that holds the rocker arm assembly was broken. Pushrods from #1 and #2 cylinder intake valves ARE MISSING.... Pulled the head and...

Fan's fine, Motor mounts are OK. Engine does not just vibrate, it runs rough as well. It's like it's missing on one or more cylinders. Other than injectors what can cause this? I've now swapped the known good injectors into the drivers side and there is no change. Chris

Looked at it - Nothing obvious. Seams more like a fuel issue to me

Hi guys, I bought a 1992 M998 with the 6.2 out of Barstow for a buddy. Truck had a bad water pump on it, we swapped that out and got it running. It also needed one glow plug that we changed. At idle the motor shakes badly, like it's "missing" on one or two cylinders. Cracked open 1 injector...

Thanks for the link, I can probably have a couple made for what it would cost to buy and ship that one. Just need the dimensions. Thanks!

Hi guys, I'm in the final stages of restoration of a Ferret MkII/III With the turret. I want some sand channels for the front. Anybody got some that could measure them for me? I just need the profile size "the W" dimensions and the length. I can figure out all the hole locations from pics...

No noticeable air leaks if I pressurize the truck with a glad hand. Without diving into the TM's is the unloader valve a PITA? I assume it's part of the compressor top end correct? Another Military truck guy I know told me to put a bunch of air tool oil into the Emergency side and pressurize...