-
Steel Soldiers now has a few new forums, read more about it at: New Munitions Forums!
Waterhouse's latest activity
-
Waterhouse replied to the thread 803A droop adjust screw?.So I started thinking about this. The HZ guage only goes from 55 to 65. If 1800rpm = 60hz than I guess 55 to 65 represents only 1650 to... -
Waterhouse replied to the thread 803A droop adjust screw?.I have checked the cable. I can open the door and see the cable / cam thing move when I turn the knob. When the HZ needle was swinging...
-
Waterhouse replied to the thread 803A droop adjust screw?.Now that I got the pump pins correctly in the rack, it appears the cylinders running equal and not so hot. (At least with a laser temp...
-
Waterhouse replied to the thread 803A droop adjust screw?.Some times I have seen a oil pressure fault light, but not always. The oil pressure runs about 25-30 psi which doesn’t sound good, but...
-
Waterhouse replied to the thread 803A droop adjust screw?.Good info, So today I turned all the pumps right against the pushrod tubes. Then I pushed the fuel lines on. This was very difficult...
-
Waterhouse replied to the thread 803A droop adjust screw?.Are you talking about the rack inside that controls the pumps? How would I know if it was moving fast or slow? The lever on the outside...
-
Waterhouse replied to the thread 803A droop adjust screw?.I will adjust the pumps to be against the pushrod tubes, although I think I have had them real close already. The stop screw is safety...
-
Waterhouse replied to the thread 803A droop adjust screw?.I was mistaken when I said the E-stop was faster. What happened was I turned the switch off and it kept running, so I hit the E-stop and...
-
Waterhouse replied to the thread 803A droop adjust screw?.What is the FSS
-
Waterhouse replied to the thread 803A droop adjust screw?.I’m assuming the S1 is the main control switch. What is the L5?
-
Waterhouse replied to the thread 803A droop adjust screw?.First, to everyone, the selinoid slams forward (or back) the second you turn the switch to off by either means. So there’s nothing wrong...
-
Waterhouse replied to the thread 803A droop adjust screw?.Ok, I have confirmed the selinoid works in both cases. I just didn’t wait long enough when I turned the knob to off. That brings me to...
-
Waterhouse replied to the thread 803A droop adjust screw?.This is an old thread I started and got so frustated that I quit working on the generator. I finally got back on it yesterday. I got a...