Recent content by winterton1

could anyone tell me if this is an evens fan clutch i need to rebuild it and saw a kit on eastern surplus and want to make sure im getting the right one?

WOW that picture is exactly what i needed.. THANK YOU

m939 its an old hard copy i have i don't have an m923a2 one.

does anyone have a diagram for the fuel tank. for the life of me i can find it in the tm. i need to know what the pick-up tube goes in to at the bottom of the tank.

OK i worked my way back from the secondary. as long as i kept filling it up through input elbow it would run next i blew out the feed line from the tank. nothing i then removed the solid feed line going into the tank . recleaned and blew it out.. FIXED .....there must have bee a...

should i not be filling the secondary filter before using the priming pump

I've change both fuel filters on m m923a2 before with no issue. this time i removed the tank and cleaned all the gunk out before changer the filters. i topped off both filters and pumped till fuel came out of the bleed screw. truck started and ran fine for a few minutes then died. i...

i just found a fourth o ring inside the small whole. I'm leaving for now because it looks ok.

one o ring was split and another had disintegrated,

THANKS

My fan actuator is leaking air from the smaller hole on the end cap. i cleaned and lubed it but still leaks air. i was wondering if it should have an o ring. it did not have one when i took the cap off?

i havee an actuator that is leaking air through the tiny hole - not the larger hole in the end cap...i cleaned and lubed it. still leaks. should there be an o ring in there. when i took in apart it did not have one?

THANK you so much!

forgive my ignorance - what engine oil weight do i use for my 923a2?

sign me up and merry christmas