Recent content by Wolfe

Ray, please email me the information on the mep-003a oil filter adapter. My email is Markwolfe@highcountryappraisals.com. I contacted you a few months ago but it will not let me enter information being im a new member. Thank you, Mark Wolfe

Sorry but im too old to figure out how to PM you. Could you please PM me? Thank you!

Ray70 are you still selling the mep-003a oil filter adapters. Sorry to bust in on this conversation but having problems PMing Ray70 Thank you

HI, Do you still sell the mep-003A OIL filter adapters? Thank you

Thanks in advance for any help with my new problem. Went to start my generator and the switch was just a little hard to turn, turned it to preheat and it did not click like it normally does when you turn it to preheat. About 5 seconds into the preheat I heard a switch clunk. Engine turns over...

I looked but was unable to find any jumper from the two post mentioned in the other thread. I did however, find two or three post that were loose.

the charging problem is that i guess you loose about 30% of your total amps usage when you only use two of the three phases when the switch is in 120/208 three phase. This 10Kw generator is replacing a 5 kw one so im thinking i will not need all the power that the generator can produce. Just...

Got my new to me 003a up and running great. Charges great on 208 three phase and 120 single phase. All gauges work great also on these two settings, but when you switch to 120/240single phase the %load gauge is at 110% and the motor loads up. Checked the power lugs and no volts are showing. My...

If you dont ever idle the motor is the voltage regulator still a weak spot in the system? Just wondering if its something that should be updated to head off any problems down the road. Is there a thread where all the 003A's weakness are addressed or are the machines so over built that they dont...

Thanks so much for your help. I will make sure to not idle the unit. Going to take a little time getting used to hearing a cold diesel rev up when its still cold. But, based upon the information on this site, its the way the motor was designed. Thanks again for your help, Mark

Hi, new member here with a question on running my Mep-003A. Is it ok to idle these units to warm them up and cool them down or will that do harm to the electronics? Also, is it ok to run the generator without a load on it as long as the breaker switch is turned off? What does the term...