Recent content by wrench

GL was SLEAZY!!! After 2 years, 9 trucks, 2 generators and a trailer-$20,000.+ I bid on an m816 wrecker ( this is the only time I put in a reserve and at the last minute someone-GL- jacked it up) anyways I won the wrecker, submitted the EUC on time, as always, got the "sent to Battle Creek" and...

Are they owned by government liquidation?? sounds like the same scam.

Turbine Blows Flames HELP! Finally getting around to messing w/ the Turbine. The transfer fuel pump will run supplying fuel to the secondary fuel pump(high psi) when you hit the start it will fire once (with flames coming out the exh port) then wont fire again. Checked with multi-meter and it...

28 volts is ok but what about the 360 amps

what fuels will this run on??

[What would this Xm211 be worth, not sure if engine is stuck(dont think so) all glass is broken but all the frames are good, original hard top is in really good shape, has a winch, no bed but my have a m35a2 bed to install. Does not come w/ the aparatus on the back. Thanks.ATTACH]173674[/ATTACH][

Run your hand underneath the doors-most PA trucks have big holes, the front fenders where the seams are are also rusty. A couple of the trucks had patches welded on the cabs( not shown in the listing). You are buying as is where is, and I have always taken that in to consideration and dont hold...

I really havent gotten bit by buying these trucks yet, so I figured I would pull the drain out of the T-case to see what come out. Normal shavings on the magnet, so I filled er up with parts cleaner and took it for a ride, it didnt take long and the front axle engaged (on ice ) like it should...

I was there last week picking up an 818, looked at some of the dueces coming up, really rusty trucks, some had patches welded to the bodies, couple had no brakes( not in listing) I think aim going to sit this one out.

Just picked up an 818 tractor, was trying to figure out how the front axle engages(on ice) noticed that the front drive shaft didnt turn when the rears were spinning, then tried it in reverse and the front was spinning( I actually had the truck against a cement wall with it throttled up) is...

Looked at those last week while picking up my 818 tractor, seen alot of rust!!

I was told there is a difference in the fifth wheel plates and king pins between military tractors and over the road trucks, IS THERE???

The other day we I was pulling a tree top across the road and the winch line doubled over itself and jammed against the rod on the bottom of the winch between the two housings. After some prying I got the cable free but there was gearlube leaking out the pass. side half. I didnt see any any...