-
Steel Soldiers now has a few new forums, read more about it at: New Munitions Forums!
WWRD99's latest activity
-
WWRD99 replied to the thread Gen1 trouble.Ok so this makes no sense. If the brown wire has tested good from the cluster to the alternator it has to have power at the alternator... -
WWRD99 replied to the thread Gen1 trouble.All you need to do is test that brown wire at the cluster to the alternator. That will tell you if it's good or not. If it does not test...
-
WWRD99 replied to the thread Gen1 trouble.Ok so you don't have power on pin 1 on the double pin plug that goes to the voltage regulator. The brown wire. You have power to the red...
-
WWRD99 replied to the thread Gen1 trouble.The ground is the voltage regulator in the alternator. The test in the sticky will tell you what's wrong with the system. Sent from my...
-
WWRD99 replied to the thread Gen1 trouble.Ground comes from the alternator. The test in the sticky goes over it easy. Sent from my SM-S906U using Tapatalk
-
WWRD99 replied to the thread Gen1 trouble.So having voltage on both sides of the gen light bulb means the ground isn't there. I use a PowerProbe to test those bulbs before I put...
-
WWRD99 replied to the thread How can I test a starter?.If you have a burned up starter solenoid there's nothing you can do to get it to turn over with the exception of tapping it with a...
-
WWRD99 replied to the thread How to refurbish door cards?.I found some at a body shop paint store in a quart size. I can't recall the brand off hand. Sent from my SM-S906U using Tapatalk
-
What kind of paint did you use?
-
WWRD99 replied to the thread How to refurbish door cards?.Only time I've had good luck getting paint to stick and not scratch off was heat. I started with a heat gun and got the panel hot then...
-
Hi folks. Does anyone have experience with refurbishing sun-faded door cards? What did you do? I've got the door apart while I...
-
WWRD99 replied to the thread CUCV early Glow Plug burn out - What is the cause?.I don't think I've ever done a pump where that shaft didn't fall down into the cover pocket. I always pop it out and cover it in grease...
-
WWRD99 reacted to Commander5993's post in the thread CUCV early Glow Plug burn out - What is the cause? with
Like.
Thanks so much for the tips, now that you brought that up I think that I may have done that originally with the line. Also the rod... -
WWRD99 replied to the thread Starter's bracket - M1008 '85.I guess it could be a pain finding standard threaded rod over there. I can get it at any farm store or parts store here in us...I'm not...
-
Thanks fellas, Find 1/4 " threaded Rod here It Is quite difficult. I'm thinking about welding on top of the Bolt a stud. What about...