Recent content by ZiggyO

- 47" long by 12" wide, sits 4.5" high including base feet - base mounting feet can be adjusted along the bottom of the light bar from a minimum of 24" to a max of 50" (outer edge to outer edge) - all amber LED flash modules - high intensity LED takedowns and alley lights - rear facing red LED...

Here are some pics. Z

If you are looking for a US made military issued compression tester, I have a few NOS ones. PM sent Z

PM sent

pm sent

There is asbestos in the plenum the two heaters sit on and in the ducting that runs down behind the forward bulkhead. The way it was dealt with was to disconnect the heaters and pump expanding foam into the ducts in front wall. Then blank plates would be screwed on in place of the forward...

I plan to be there as usual with a wide variety of stuff. As a side note, would anyone be interested in a set of m1008 cargo cover bows? I would pack them only if I have some definite interest. Z

pm sent

So in the auto body world, new hinges are the fix-- however, in the event that the hinge is not readily available, we use bronze bushings . It will require the services of a machine shop, but essentially, the hinge is drilled out on center, bushings pressed in, and a new pin inserted.

I am willing to bet the pin on the upper hinge of the drivers door is shot-- We see that in my inlaws' body shop quite often. It makes sense that the driver's door is showing the issue and the pass door is perfect-- the drivers door sees the most use and many times is also used as a form of...

Nebraska is green-- thanks to a legislative bill pushed through by Senator Tom Brewer, any vehicle which one can show has a military connection qualifies for a former military vehicle tag-- this goes for foreign vehicles as well. Otherwise one can easily get regular tags for pretty much anything...

Wow, that's a blast from the past---- I got those kits almost 18 years ago and sold them all within a few weeks. Sorry, but I do not have any more.

To clarify, you are saying that you have an OEM battery that works properly in one heater and gives a low voltage code in another heater?

If he does not have a cord for the towing lights, I have some NOS cords available........ Z

On the m35 trucks the slobber tube has a tapered end for a piece of hose to slip on-- the easiest way was to use a short piece of hose, one end on the slobber tube, the other on a T fitting. (Picture a T tipped on its side). The lower part of the T would then have a ball valve, and after that a...