Search results

I have a 805b that now produces nicely, thanks forum. I am likely wording this question incorrectly but researching gensets I understand there are traditional generators and inverter gens. As I understand it, the inverter gens produce a more steady 60 hertz while traditional fluctuate more and...

Great. If one is bad, where would i find replacements?

I have been avoiding working on this but have to get this thing working again! I've printed out and reviewed the content. Looks straightforward to a point. The manual discusses breaking the rotating rectifier plastic support with a cold chisel. Where would you get new supports? If the...

Looking through the forum, I found one post for the TM 9-6115-671-14 and it was a blank PDF.... Any chance you could post it again?

Thank you, I will let you know how it goes.

Well, I am glad that is good news and truly appreciate the help! Bad news is while I am handy and can work on anything, I am not a generator mechanic so if it is not in the tech manuals you guys post or in a thread, I am in the dark. I don't know what I need to do or look at regarding the...

No, I immediately get the error message which I attached a photo of....

A whopping 25 volts.

Hello all, I have a relatively new generator... it was running great, with only 160 hours of use on it. I did my weekly hour long turn on to keep things humming and I am now getting an error message when I close the AC Circuit Interrupt. The Fault Indicator message states, Error, Low Voltage...

Hello group, So I have downloaded the CIM Brighten/Darken Specs and built out a Contrast Adjustment cable. When I unplug the P27 connector and plug in my adjustment cable, I have a beautiful color screen appear without any adjustment needed. When the P27 cable is plugged back in it goes dark...

Amazon has the numbered termination board. Found a 100 pin on eBay after buying a 68 pin advertised as a 100. Definitely non standard pin out .

I would take you up on it but I have the last of the parts, that dang 100 pin scsi connector, on the way. Ironically I designed almost same as you Without knowing it! but instead of push button, I went with rotary dial. . Used a similar termination board, also afraid I’d connect wrong wire and...

I’m using two of the three phases as a backup for house... so makes it about a 20kw set. While ⅓ less efficient as a single phase of same size, i am getting a better machine than a Genrac standby for same price. This one can run till fuel is gone, genrac only a half dozen hours at a time. The...

I've fixed my own problem.... operator error. I was not holding up the Contractor position switch long enough. Producing like a kitten...

I recently purchased a MEP 805B. I have downloaded the User Manuel (MEP805B-MEP815B-Operator-Manual) and reviewed but am at a loss. The CIM shows I am producing 220 volts but... When I go to check the output voltage at the load output terminal board, there is zero voltage. Notes: My GFCI reset...

DELETE, reposted with different title