Search results

Look at TM 9-2320-289-34P Page 3 and 3-1 to see the picture break down and the bearing sizes listed page 2 and 2-1 shows the bearing caps but no part numbers

When the crankshaft gets turned down to a new size you will have to get bearings that are sized to make up the difference. If the main journals all get turned 0.010 down from original spec you have to get main bearings that are 0.010 over original spec. They are available in several sizes. It...

I looked it up by typing acdelco 213-52. This is what came up, shows i purchased one already. They have a new picture that shows sensor also. I would contact the seller about it. I hope you get it sorted out.

I apologize if I got wrong. I believe I got both when I ordered it. I will verify my amazon purchases and let you know.

The wires in img_1218 go to the glow plug relay, glow plug temp sensor at the rear of the drivers side cylinder head. Inside the vehicle it joins the main harness and goes to the glowplug controller card. The single green wire that breaks out, does it go to the device on the drivers side fender...

TM 9-2320-289-34P Figure 251 Has the fuel pump and lines for the personnel heater in the ambo. TM 9-2320-289-20 Page 10-91 starts all maintenance for M1010 specific items. TM 9-2320-289-20 F-22 through F-26 are the M1010 specific wiring diagrams. The wiring for the heater controls to the...

TM 9-2320-289-34P Page 166-1 Items 22 and 28 GM part #6271989

TM 9-2320-289-34P Page 24-1 That sensor is obsolete use this one, it comes with a new connector. On Amazon, picture does not show the sensor, but I just replaced my old one for the same reason with this item. the manual listed above will show you every nut, bolt, part of the entire truck.

Mine was located in the glovebox also.

Sir, I have not found anyone who can make the sticker. I have recreated it myself. If you like, I will will post a copy of the file here. Use it if you wish. I am looking for 5” x5” clear tape sheets now. There is a copy of the service parts ident sticker on the inner fender? Which side? I have...

The ones I have seen with rubber mounts were the early M1031s with the M880 work box. The later ones (like mine) did not have rubber mounts because of the belt drive to the generator.

TM 9-2320-289-10 Page 2-57

In my M1031 there are no mounts. I have seen some that do have them on this site.

Making good progress!

I did a quick internet search. Brass radiator necks are readily available.

Not too long ago I read a post in the CUCV forum asking why a radiator cap would spontaneously start leaking. I did not have an answer back then. Now that I have encountered the same propblem on my truck, I have figured out why it happens and how to solve it. 1. The radiator caps are stamped...

I did think about that. I ended up taking it to a local place and having it sandblasted. It was about $2600.00. It was by the hour… $100.00 per hour. I did not expect it to be that high. Live and learn. Reading your post again, I think we are misunderstanding. I needed the power at our...

Started building an obstacle course at work. It is nice to have portable power for sanding.

A suggestion, verify that power is reaching the service light switch and the headlight switch. Headlight switches do fail.

I had to stay with my fellow maintenace truck owner. Can’t do anything without maintenance!