Search results

My P.O. had replaced the master cylinder, and it really started to leak out the boot. So, not to mess around, I ordered a new "correct" from Mid-West Military. Looking at the install,.....are there ANY tricks in bleeding this off without tapping into all the brakes? I noticed there is a small...

I have a PO installed 12 V converter in my rig that powers up some "makeshift" roadworthy-esque lighting. I am very interested in picking up a Hot Rod type 12 circuit wiring harness and running a parallel 12V system to relamp and put some turn signals, etc. on my rig. I did a brief search and...

I just replaced my speedometer with a like new unit I found. (109 miles) The original speedometer would bounce like crazy, so I thought, well the speedometer is shot. The new one bounces a bit, but I have come to figure that my newer cable, via the PO may be binding. Please look at the photo...

I have done a search, and found some real close responses to my question. My clutch pedal is well proud of the brake pedal, I'm not the tallest at 6' 2", but I really have to strain to plant my hoof on that thing. Once there, I'm good until I stop. I laid underneath and stared, as well...

Looking to order a fuel access cover for my M37. What hardware is required. Did an online search, and found nothing. Thanks!

Within my rig the PO installed a 12v converter. This runs a whole separate circuit for a pair of LED lights in the place of the blackout lights, and trailer lights, stand alone, in the rear for running/brake. Nothing for origional lighting works, and I believe the oem light switch is junk. The...

My dear 6 cylinder started to really mark it's spot on my garage floor. The pan bolts in one area were at best finger tight, so I addressed that..... The bottom of the flywheel drain/observation plug is missing and that's all "dry". The drip issue comes off the back of the pan adjacent...

Just received my lifter cover gaskets for replacement of my very tired current installation. Fel-Pro from Vintage Power Wagons. Looking at the work ahead......are there any shared tips going into this. It's not a very technical installation BUT is it worth the trouble to remove the fuel pump...

I am just taking bits and pieces of things I want to replace/repair on my newly acquired M37....... I have looked around at windshield weatherstrip, and it appears simple in design.......but read comments about splitting the metal frame to install it. I thought you could get the old soft and...