Search results

I own a m1031 with a long bed on the back. I ordered a new bed mounting bolt set from LMC but it only included 2 "long" bolts which are not quite long enough to bolt all the way through the frame. Look to be about an inch shorter then 1 long bolt that was on the truck when I got it. I need...

I Need to Replace Leaky rear pinion Seal and I cant remove the u-joint! I need to replace a leaky rear pinion seal... I removed the u-joint retainer bolts but the drive shaft will not budge. The TM says not to hit the drive shaft or pry in the u joint to free the shaft ? How do I remove it...

I own a m1031 with a long bed and need to find the spacers for the extra long bed mounting bolts. I was searching through the tms to find the bolt torque and i see that there are spacers that fit into the U channeled frame to prevent the frame from bending. Any clue on the size of this...

This is a test post.

M1031 - wheel bearing removal I am going to replace the rear wheel bearings, races, hone the drums and replace the brakes and wheel cylinders. I removed the Inner bearing seal, bearing and race with the autozone puller. When i tried to remove the snap ring for remove the outter bearing and...

When I bought the truck the glowe plugs were wired up to a manual switch.. I purchases an installed a new board from cucv electric (works great thx guys) and had to re wire the system (the glow plug relay was installed upside down ... The secondary leads were on the right terminals but the...

I have decided to remove the pto shaft and rePlace with the cover plate until I need the pto... I didn't think this would be hard at all , but it is. I simple can't just unbolt the pto from the transfer case because the shaft's bearing are supported by the truck's frame. The pto belt pulley...

I just purchased a m1031 with a pto. My truck does not idle high then low. It just idles high. I recently purchased a tach so I know how high it is idling. My fast idle solenoid is not contacting the throttle linkage. I am obviously missing some part. I will post a picture later on the...

I just bought a 1986 m1031 truck last week end from a Steel Soldier Member (Great Experience!) I had been ghosting on the forum for a few months researching and waiting for a good truck that was some what local. Long story short I'm in the process of changing all of engine/gear oil in this...