Search results

Anyone have an extra fuel injector line for the number 5 injector? In the process of removing my injector pump to have it rebuilt I did not notice the injector turning when attempting to remove the #5 injector line and it twisted the line at the nut and broke the line. So I am now in the...

Working on my son's M1009; it is having problems with hard starting, and I have read many good suggestions here. I finally figured it was time to replaced the leaking (fuel) fuel pump with a NAPA part. I had to remove the metal mount plate to put grease on the push rod so it would stay up in the...

I purchased a rebuilt engine for my MEP003 10kw generator, I have searched here but cannot find any information on how to break in the engine properly. Does anybody know the proper procedure, the best oil to use, how long to run it, and under what load etc?

I have been searching for a while and have not found this yet: I found a list of all the grounds, but not a complete description where the grounds are located on the vehicle. I would like to remove and clean all of the ground points to eliminate possible electrical problems, I have found a few...

I have been going through a newly acquired M1009, the transmission was low on fluid, I serviced the transmission with new fluid and filter. I Started and drove it to test for further issues; I notice transmission fluid leaking from what looks like the shifter shaft at the transmission, I am...

My M1008 is leaking fuel at the injector, best I can tell it is leaking from the connection to the line. I recently had the injector pump rebuilt, when I put the injector lines back on, this one line and two others leaked, the other two stopped when I tightened them, but this one injector will...