Search results

HI, Noticed that one of my Quick Exhaust Valves is missing the rubber part that is on the output that keeps junk (dust/dirt) from going backwards into the valve like a flapper. Not sure where to acquire one of these? Looked around a bit and found nothing. Any ideas? Thanks!

HI again, Went to start my 5ton after sitting for a week or so and it fired right up as it always does with 1 sec of cranking. let it warm up and moved it 50' and shut it down. Then go to start it 3hrs later 70 degrees outside and it took 3 attempts cranking to get it to start, then the same...

Would a bad unloader make the compressor kick on too fast ? Put a pressure gauge in the wet tank to see why it kicks on in 15 sec after it shuts off. My wet tank drains down to 107 from 125 in 15 seconds then stops draining when the compressor kicks on so the unloader is doing somthing here...

HI, M925A2. Here is what is happening, when the ctis cycles on first time start up it blows out the quick exhaust valves as it should (nice and loud) but when you drive it a bit the blow offs get very weak on the CTIS Quick release valves when the system does the normal 15 min cycle. (it...

HI again, M925A2. When I started the truck and let it idle for 20-25min to warm up like I always do; the hwy CTIS light blinks like it does to set up the system (this maybe takes 15min to do at idle before going to a solid light) then I noticed the top two lights where solid (hwy and XC both...

HI, Trying to trouble shoot the Ether start system that does not currently work. After using the VOM and blowing air through the ether hose I found out that current is not going through a switch (assume it is a temp switch mounted on the engine block). Wired around it for now with a jumper...

HI, Does anyone know what the Hydraulic specs are on the hydraulic system for my M925A2 truck? <Mainly wanting to know GPM and PSI that the system can provide. Thanks!

HI All again, On my M925A2 I was driving off road like I always do in HWY mode, (cuz I do not want to mess with the CTIS Settings). And the top 4 lights started flashing while driving, shut the truck down and looked for an air leak, because I assume that is what the 4 flashing lights are for...

Hi again! From what I have read in the manual and on the dash, it sounds like you can not use reverse with the transfer case in low range. Can this possibly be correct??

HI, The truck is a 1990 M925A2, new to me. The fuel gauge reads full, and from reading on the forum on searches it sounds like a ground issue. Anyways, I have 24VDC on the back of the gauge when I unplug it, so I assume that is right. Then at the sender I have 6VDC from the plug on the...

HI, Trying to replace the winch cable on my M925A2. Taking off the old crimp on end it busted the inner wedge. (took a bunch of heat and a large impact wrench to get it off). What is the crimp on end between the chain and the cable called so I can research it to buy used?? Or is there...

Hello! I have purchased a M925A2 truck. I saw the sticky above with the filters that are needed and for sale at NAPA but it says they are for the M939A2; are the filters the same between the two trucks?? If anyone has the list of all the filters for the M925A2 at NAPA that would be great...

HI again all! Tried searching this but couldn't find much. Does anyone know of a shipping company that has dealt with GL pick ups? Looking at WI going to MN. Have tried calling and quoting FastTrack Logistics without any luck. Any info here would be great!