Search results

I just went to start my mep-003a and found that the lower ball joint on the governor linkage is cracked down the whole length of the threads, thus will not thread back on to the linkage.Heres where I need help , I can't get it off because it hits the side of the IP when I try to slide it out ...

Can someone please tell me where to find the mechanical governor adjustment ? I have looked thru the TM a bunch of times and can't find it. I hooked the unit up to my house and and load tested it and it runs great ,we were pushing over 80A but the hertz would max out over 65 and we had to...

I am wanting to charge my batteries on my MEP-003a and I am going to use two 1.5a batt maintainers , ? Do I have to disconnect the cable between the 2 batts (series) or can I just put one charger on each batt without damaging the chargers and/or batteries and Leave the 24v series intact ? Thank...

Hello STEEL SOLDIERS, This is my first post here so I hope im in the right spot. I just picked up 2 genny's and when I went to clean the FUEL PUMP strainers they just fell out and I don't know which way they go back in (small hole up or down) I swear one was in each way . Or does it even matter...