-
Steel Soldiers now has a few new forums, read more about it at: New Munitions Forums!
Search results
-
G
M1008 Glow Plug System Issue, No Wait Light, No Start
I have tried to read as many threads as possible before posting this question. Have a glow plug system issue where the Wait Light does not come on, GP Relay cycles every few seconds about 6 times then stops cycling (GP Relay 1 year old) and no start. Batteries are fully charged, Engine Control... -
G
86 M1028 Charging / Voltage Gauge Issue ?
Looking for some advice with what I think is a voltage gauge issue that when truck is running gauge stays in the high end of the yellow range, never goes into the green range. New belts, new drivers side alternator, 2 new Optima Red Tops. With truck off, front battery voltage is 12.5 and rear... -
G
M1028 Gen1 Bad
I have followed all the wonderful threads with regard to alternator issues. Have determined that Gen1 alternator is in need of a rebuild. Going to order the rebuild kit from CUCV Electric as many have suggested. Was also thinking of buying a new alternator from Rare Electric " OEM Isolated... -
G
Blower motor keeps blowing fuse
Having a problem with the blower motor blowing the fuse on my 1986 M1028. This problem just started yesterday, before that blower worked normally at all speeds. Now when I turn the blower on with the truck running the fuse blows and the Gen 1 light comes on. When I turn the blower switch off the... -
G
Stupid Me
Have 86 M1028 that ran like a swiss watch. I am installing a Western plow and while drilling a hole in the passenger side frame for plow mount I drilled the lower fuel line. I have replaced the damaged fuel line with a section of rubber fuel line and now truck will not start. Truck starts for a... -
G
Looking for M1031 Bench Seat
Dose anyone have a good condition bench seat for a M1031 near Michigan? Mine came with M1009 seats in it. -
G
M1031 with Hobart G204 Welder Help
Just picked up a M1031 Contact truck with a G204 Hobart Welder. Tried to start the Wisconsin engine of the welder and the starter just clicks. Thinking it has a bad starter. Dose anyone no how to get at the starter for removal? It is located on the back of the engine up against the front wall of... -
G
CUCV Jump Start
Dose anyone know if you can jump one M1008 from another M1008 with out slave cables? Only have regular jumper cables. If so, how would you hook up cables to batteries.