Steel Soldiers now has a few new forums, read more about it at: New Munitions Forums!
Microsoft MSN, Live, Hotmail, Outlook email users may not be receiving emails. We are working to resolve this issue. Please add support@steelsoldiers.com to your trusted contacts.
Trying to install my roof side rails on my M1123 to install new 4 man top and the Windshield and B Pillar holes are to large, both sides are missing the treaded nut inserts. Has any one been able to make or has anyone been able to fill in the holes to make new treated inserts work?
1998 M 1123 HMMWV -Got the rear drivers caliper off , disassembled, and dry fitting to rebuild after dust boot and piston seal failure.
following
Rebuilding Rear Calipers
By Gilbert Herman
December 5, 2005
write up.
Excellent write up. However having issues with a rebuild, the thrust screw...
Help, again! I have looked locally at older model 1992 HMMWV with no luck being able to figure out where the wires come from to connect the speed sensor or temp sending unit, as they do not have or are missing the same things I am missing.
I have a 1998 M1123 HMMWV missing the connection from...
Great news, got the engine up and running, no leaks and holding oil pressure and water temps, got brakes, lights, all engine systems seem to be normal.
However, now on to the deep end -- I don't know any thing about the transmission, after getting the electrics all sorted out and getting...
I have searched the forum for any tips, tricks on the fuel pump installation. Not having much luck. I purchased 1998 M1123 with 6.5 L diesel, no fuel pump in the truck when picked up. New pump is back in, push rod, and hoses., Any advice, tips, or tricks on getting the pump up and...
Hello again, well lets play what is this again. This wire is coming out of the passenger side battery box are, it appears to have been (was) connected to either the positive or Negative on one of the battery post. But which one. Any help would be greatly appreciated. Also what should...
Has anyone made measurements of the C pillar and put into cad or dfx.file drawings? My son has CNC plasma table, I would bet he could cut it out in 3 pieces/4 pieces for 1/3 the cost.
I am the new proud owner of a 1998 M1123, I have a couple questions about the wiring and can not figure out why they removed the front drive shaft on this vehicle and left it on the front seat?
Wiring question., Does 14 B wire go on to the white block on the side of the starter, I have...
Sure, ad-blocking software does a great job at blocking ads, but it also blocks useful features of our website like our supporting vendors. Their ads help keep Steel Soldiers going. Please consider disabling your ad blockers for the site. Thanks!