Search results

Does anyone have a photo showing the location of the crank position sensor on a 1151 6.5L Turbo? When I turn the engine on the trans light remains on, so want to check that sensor connection since the TCM doesn't see the engine running. Did a bunch of power washing off a decade of dirt off so...

Update, solved the issue and it was not the tail light or the flasher, turn signal handle. Wound up being a hidden issue with the rear side original LED marker light. During this whole investigation that light worked fine it looked like. Lit up fairly bright, and I only went to replace it...

I can confirm the issue followed the light fixture when swapped, so I'll have to get that swapped out. Opened it up but the wires go into a sealed compartment where the board is so no accessing anything without destroying the light..

Good idea, I'll give the swapping a shot when done with work today.

Mogman - when removing the ground I get no lights. Grounding issue would make sense, but I followed your recomendation and ran a wire from the negative battery terminal and had same issue. juanprado - Not an OE light, aftermarket with integrated reverse lights so I don't have extra lights...

Starting to think its an issue with the light fixture. Old tail light had no issue. I grounded with a wire from the negative battery no change. In stop light mode flasher works correctly even when brake pedal pressed. In service mode, hazards make the light flash normally but not when...

Spent time making sure the grounds were clean and making good contact with the metal crossbar on the back of the light. In the tail light area where would I pull a better ground to verify that's the cause? The part I find most confusing is it works normally in stop light when hazards are on...

Pretty stumped on this one so would appreciate any help. Installed LED tail lights with an integrated reverse light. They work great, the left side is flawless right side is the reason for the post. The right tail light has an issue with the turn signal. Turn signal works great in stop...

That's definitely it, thank you Coug. Looks like it's just missing the tray.

Have a newly acquired USMC 1151. Haven't found this swing arm pictured anywhere, and looking to find out what it was used for? Thank you in advance for you help