Search results

I was able to find a company that builds these tanks. I don't see any dimensions listed for the tanks though so I don't know if they would fit our 803s. Not sure if I can post a link to that website on here.

Hey everyone, I was able to successfully start the generator up and put a small load on it through the front 10 amp courtesy outlet. Thanks for all your advice on the project.

Thanks for the advice. I was out checking wires (before is started to rain) and found 4 more 20 AWG wires that were chewed up.

Will your run of the mill heat shrink connectors be sufficient in the AC section.

Thanks 2Pb...that is a dang good idea!!!

I am also planning on replacing the one terminal strip that has rodent waste on it and some of the terminal end.

Thank you, all. I have my work cut out for me. Taking a four day weekend this next weekend so I should have some time to start doing this. Do you recommend replacing these wires end to end rather than a splice. That is my plan anyway, just wondering what your advice is? I did not think to hand...

Here are the wires that I have no idea where they go.

Here is the first set. I believe these wires go to the current transformer. At least that is what I can tell by looking at wire numbers and the diagram.schematic

I have some many pictures I could build a photo album. lol Will include some shortly i.e. when I figure out how to get them from my phone to my work computer and on here. Will also include some of wires that I have no idea where they go (completely chewed in down to the terminal end.

Ok thanks will look for it

Hello everyone, At the first of this thread 2Pbfeet said he was looking for some wiring. I to am looking for wiring but have not been able to find the 10ga or 20 ga wire needed to replace what's left of mine (rodent problem). Can anyone point me in the right direction?

Thanks Kloppk, The voltage regulator is not installed as of yet and have to look at the wiring diagram to know how to wire it up anyway. I will be putting it back together today. You were right, it is a lot easier to work on with the top removed.

I have an 803 with 405 hours on it. When I got it, the thing was missing one panel and the voltage regulator, all fluids have been drained, the oil and fuel filters were also removed and the batteries were also removed. The fuel tank drain was also missing. I have a borescope and have looked...

Thanks K. Will look there. I appreciate all the info available on this sight and all the guys who take time out of there day to provide that information.

Does anyone know where one can pick up the filter element fluid?

I agree with what Guyfang said. Have a good look at it before you buy it to make sure all the parts are there. I'm dealing with this issue now. Didn't do my due diligence and bought an 803 that doesn't have a voltage regulator. So if anyone knows where to find a VR let me know.