Search results

Hey Guys- I've had a brand spanking new Bridge Plate kit sitting on the floor of my M1009 since the day I (re-)acquired it. I finally went to install it and realized that there may be some missing pieces. Does anyone have any closeups of what their bridge plate looks like? The 2 places I am...

Hey Guys- I am actually about 90% of the way through making some modifications to the gauge panel on my M1009. I am replacing the dummy lights with gauges (well, one of them anyways). I am planning to do a write up on my conversion which includes a fair number of pictures (I've snapped about 80...

Hey guys- Well, in my quest to perform some upgrades while fixing some issues on the M1009, I ran into a question/issue. From reading around, it sounds like the "Gen 1" and "Gen 2" lights serve an integral in the charging system of the Stock M1009. In my case, I have converted from 24v to 12v...

Hey guys, finally found the time to finish up my 24 to 12v conversion on my M1009. I have about 90% of the conversion completed, and just have a few pieces left. Specifically, in the Roscomm instructions, step 10. It says to remove the red 14-gauge wire on the smaller stud. They say that...

Hey Guys- I have a question for anyone who has installed aftermarket gauges in their CUCV. I am looking to replace all the dummy lights in my CUCV with "Real" gauges. I don't really want to remove my old ones, but rather just install the new ones in front of them. That way I can have the dummy...

Hey All- I'm new to this board. I was recommended over here by Magnus who has been a great help to me. So, the short story. Have an M1009. It has had 4 owners since the Military, 2 of them have been me (Long Story). Low Mileage, 26,800 or so right now. Always runs and starts like a champ, have...