Search results

Well I finally got the parts Through AMAZON (ordered a 10 pack for $30 ) and they work just great >[thumbzup] thanks to all who responded.

Thanks I really appreciate it

well.... after doing a lot of searching online I found a thread on smokestak and found Part # E-Z-GO 24465-G1 It looks like the same socket and even has a T stamped on it so I will go ahead and order it and see if it works,sigh...

wow, they have a lot of stuff on there but i dont know what size to order

So when I get a new ball socket I should only use the new socket with the female threads and leave the original ball on the bracket? If I get a metal ball/socket will I be able to pop it back on? Thanks

I just went to start my mep-003a and found that the lower ball joint on the governor linkage is cracked down the whole length of the threads, thus will not thread back on to the linkage.Heres where I need help , I can't get it off because it hits the side of the IP when I try to slide it out ...

Thanks everyone , your help is greatly appreciated , I put the same setup in my barn so I can exercise and run the Genny without dragging it up to the house , I will see if I can borrow my friends Hz meter . Also has anyone ever replaced the gauge with a digital Hz gauge?

Could you please explain droop to me, does that mean at 60 Hz when a load is put on it will drop so many HZ? because mine actually went up maxed out the meter over 65 hurts when I put a heavy load on it

Thank you so much for the reply, do I adjust it at full load or only half load or zero load , Or does it even matter?

Can someone please tell me where to find the mechanical governor adjustment ? I have looked thru the TM a bunch of times and can't find it. I hooked the unit up to my house and and load tested it and it runs great ,we were pushing over 80A but the hertz would max out over 65 and we had to...

Thanks , I feel the same way about -/+ meeting in the middle something just does not feel right about that , I have three battery 12v trickle chargers and don't want to buy another , Thanks

I am wanting to charge my batteries on my MEP-003a and I am going to use two 1.5a batt maintainers , ? Do I have to disconnect the cable between the 2 batts (series) or can I just put one charger on each batt without damaging the chargers and/or batteries and Leave the 24v series intact ? Thank...

I store the gen in my barn so I really don't want to drag it up to the house every month to exercise it , The water heater sounds like a good option and I might have a couple laying around somewhere.

Wow,thanks for the pics, that was just what I was lookin for , that really helps. how about the fuel PUMP strainer,do you remember which way it goes into the pump? I did print the whole TM and have been doing lots of reading, Thanks Again

Hello STEEL SOLDIERS, This is my first post here so I hope im in the right spot. I just picked up 2 genny's and when I went to clean the FUEL PUMP strainers they just fell out and I don't know which way they go back in (small hole up or down) I swear one was in each way . Or does it even matter...