-
Steel Soldiers now has a few new forums, read more about it at: New Munitions Forums!
Search results
-
A
Power steering issue on a gas converted m1028.
I put an SBC 350 in an m1028 and the power steering will not kick in until I rev up the engine. I'm wondering if I need to put a smaller pulley on the power steering pump or what might be the issue. I put a rebuild kit in the pump before I installed it. My thought is that it may be turning too...- alex33072
- Thread
- Replies: 8
- Forum: CUCV Hot Rodding and Modification
-
A
Snowblade for my m1028.
What should I look for to find a compatible mount? I assume it will be a Chevy square body pickup? Are the years and models pretty comparable? Anything I need to look out for? Thank you.- alex33072
- Thread
- Replies: 2
- Forum: CUCV Hot Rodding and Modification
-
A
Vacuum brake booster and master cylinder for modified m1028
I got a vanilla m1028 a while back that had a bad motor. Removed the diesel engine and I'm putting in a 350 SBC. Has anybody had experience putting a vacuum booster and master cylinder in from a civilian comparable pickup truck? Am I going to have issues because of the larger brakes on the 1028...- alex33072
- Thread
- Replies: 7
- Forum: CUCV Hot Rodding and Modification
-
A
Speedo reads too slow.
I put together a M1009 from parts obtained from various sources. The transmission came from a M1008, I think. After looking through some manuals it appears there is some sort of regearing box that the speedometer cable plugs into rather straight in the way I have it. Is this correct? Am I... -
A
Rearmost drive shaft on M35a2
Real quick question. About 4 years ago I removed the rearmost drive shaft in order to make the duce turn a little better. Now I'm getting ready to sell it and want to re-install. I forgot if the slip yoke goes toward the front, rear axle set one, or rear, rear axle set two. I feel like an idiot...