Search results

My 2 MEP831a's arrived the other day. One is a 2005 with 30 hours on it. I blew out the fuel lines and some horrific fluid came out. I changed the fluids and filters and added fuel and fired right up. Runs fine and produces power as it should. Now for the 2nd unit. It's a 2001 with 1100 hours. I...

I used my hands. I was really worried about breaking one of the plastic T's. I pulled the 2 end lines first then I pulled the vertical ones up and slid the top ones off. I used the needle nose to connect the top middle one back together. It was tight under the exhaust.

Here is a pic of my old lines.

Oh, they are push on. No clamps needed.

There are 4 T connectors at the top of the motor, one for each cylinder. There are 4 vertical lines also that connect to the ones that run horizontal across the top of the motor. Those braided lines are maybe 1/2 in long. I pulled them all off. They can be fragile due to heat exposure. I just...

I just picked up my 803a and the return lines were leaking terribly. Past the point of weeping. Found a guy on Ebay out of MD that has 3.5mm braided yellow stripe return lines. I got 6 feet and I was fine. I did not need to replace the long piece though. The one at the top of the head to the...

It lives!!!!! Once I got it home And cleaned it up, I went over at the major components and made sure all was tight an present. I lowered my old cell phone down into the tank to make sure I got all the shop towels out and found some of Kuwait had come back with the generator. I opened the drain...

So I did my load out today. Everything went fine. Iron Planet employee brought it right out to me on a fork truck and perfectly put it right on the pintle hitch. I hook up my 12 pin to 4 flat and it worked fine. I swapped out for 2 1156 bulbs and 2 #67 bulbs and they looked good. The engine...

Thanks again. I just added to the thread I started. Check it out.

Awesome info thanks!!!! I made a 12 pin to 4 flat adapter for the lights also. I am lucky on distance, only an hour drive for me.

I attached a picture to my original post. I am taking a 1500 pick up. Thanks for the info.

I just added a picture. Using a 1500 pick up.

I won a MEP-803 and I am picking it up on Thursday. Had a few questions about picking one up. Does the front tounge have a crank on it to raise and lower it or is it all muscle work? Is it well balanced that one person can lift it or do I need to bring someone to help me lift or lower it onto my...

This is my first post and tying to attach a picture. Picked up these seats today. Not sure what they go to.