-
Steel Soldiers now has a few new forums, read more about it at: New Munitions Forums!
Search results
-
A
Need Help, HWWMV Armor doors
I need to replace some rivets to attache the armor door to xdoor. Does anyone have a part number or a place to order these from? Thanks -
A
Turret Ring Clips
Does anyone know where I can get these clips. They attach to the top of the turret bearing ring and push the roof down on to the turret support. The ones in the TM have a higher rise about an inch. The ones I am looking for are about 1/2 inch high. I need 10 of them. Anyone know of any... -
A
WTK - Do these have any value?
Pulled this out of my 2001 Slant Back. Do these have any value? -
A
HMMWV Hoods
I am wanting to move my M998 -1988 hood to a M1045a2 -2001. Are these the same hood or were there different hoods for different variance. Any input would help. -
A
M998 tan cushions
Been trying to find the part numbers for my tan 2door HMMWV. I can not find them in the TM. Does anyone know where I can get the part numbers for the tan passenger bottom and seat back? -
A
Rear Right Tunnel Insulation Panel
I need some help finding a green rear right tunnel insulation panel for a four door HMMWV. I can find plenty of left hand sides but know rights. I can not even find a part number for it. Does anyone know where I can find one? Interesting why there are not for the right rear side. -
A
M1123 Fill Up
I filled up my new M1123 for the first time and when is was topped off, it over flowed some where from the tank. Is this normal? My m998 does not do this? -
A
HMMWV Sun Visor Screws
Does anyone know the screw size and thread count that is in the windshield frame for the sun visor mounting location? Went to mount mine last night and the bolt in the frame were full of paint. Let me know. THank -
A
HWWMV Overheat Problem Fan Clutch Friction Pads
OK, I have read every post on HWWMV overheating problems and found that my fan clutch Hyd, TDU and Fan clutch work fine. The fan moves back and forth when the TDU is disconnected but no engagement of the fan. There is also on power loss so I know it must be slipping on the friction pads... -
A
HMMWV Gear Hub GO Amount
I am working on my new 1988 HMMWV and was replacing all the fluids. The manual states to for the gear hubs to add a pint of GO. What happens if you fill it up to the bottom of the fill plug? Do I need to drain it down to a pint? or leave it alone. Any help would be appreciated. GB